Search:

Nice. No problem with a donation but Paypal would be a better way to go.

Scott

Thanks for the responses guys.

Hi all. I'm in search of a long running or repeatable Ivy or vine pattern to use on door and window casing. It will be going up the casing sides, then the top piece will have a quote on it.

TIA...

Great advice guys, as usual. Thank you

As picky as the CW machines can be with the material that goes through it, has anyone had success carving on rough sawn pine?

Things sure get complicated.

Right o on the jog to position, as that was what I was using. I'll do it a different way then. Good job. If there was an up vote button I would use it.

Ok ole wise ones. I have a pattern that is nothing but cutting out a pattern with the 1/8" straight bit but the machine always ask for the 1/16 carving bit before it asks for the 1/8" straight bit....

hmm, I didn't think of it that way, just words and a picture. Thanks for the input guys.

Anyone with the better software (than me, I'm at the lowly bottom yet) will ing to convert this Vietnam JPG to a ptn?

As always, thanks in advance for the help.


Scott74754

Good job bud!

Anyone have a pattern something like this
74466

I saw it on Fb, it is on the Freedomoutpost.com website. I emailed them to see if it is copyrighted and if not I'll get a bigger flatter picture. Thanks for the response.

Anybody with the better software willing to convert this to an MPC for the group?
74411

Thanks for info Al.

Thanks as usual for the insight guys. Al, sell me that machine.

Has anyone ever tried to lightly engrave a brass plate with their CW?

I like the term "air carving". So of course I stopped it and awaited for what I knew would be helpful advice from the group. Examination revealed that a small piece of wood from the carving had...

So I have been a having a bit of a problem with my CW being very finicky, but as of right now, it is in the middle of carving a 10" long project, which it did fine for about half of it but now it...

I have the font installed as instructed, it shows up under options for text, but what key combination would I press to get the symbol to show up where letters/numbers would normally show up?

oooohhhhhh, the more money thing. :) Thanks

Thanks guys. and Docwheeler, I too tried the wing ding route with the same result before asking for help. I am making a picture frame for some photos of my grand daughter and I and thought it would...

Well, you guys got me thru my projects for Christmas, thanks for the help. Now I need some help with the infinity symbol. All I'm looking for is a pattern of it that would be similar to Centerline...

Thanks for the help guys. Will give the suggestions a go and see what happens for me.

Bit optimization was set to Best, bit is new from CW. Upload was Normal.