Search:

Type: Posts; User: dragoncarver; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    65
    Views
    70,964

    Sticky: thanks

    problem solved i had to get a new module and now it does not ask to jog to position or cut so deep in one pass
  2. Replies
    65
    Views
    70,964

    Sticky: cut depth

    if i cut .625 is it going to try to cut this in one path :o i had depth set for .125 it is cutting .25
  3. Replies
    65
    Views
    70,964

    Sticky: cello

    i would be happy to give you any measurements from my cello if you need them/ the bit does cut but the flex shaft shacks quite a bit it does not get hot still how do i get the old version back on my...
  4. Replies
    65
    Views
    70,964

    Sticky: violins

    wow i just noticed that you make violins. i am a celloist my son plays left handed strat not as well as jimmie ( i hear dead musicians on the radio :roll: )
  5. Replies
    65
    Views
    70,964

    Sticky: multi pass cutting....

    cut depth is .125 i clean the bits and i did lube the shaft i touch the shaft and it is slightly warm my question now is i want to go back to multi pas cutting how do i do that at this time i am...
  6. Replies
    65
    Views
    70,964

    Sticky: multi pass cutting....

    ok i did a search now how do i get the firmware back on my card i do not like it cutting in one path i have not had any fires but i am afraid my machine will over heat
  7. Replies
    65
    Views
    70,964

    Sticky: multi pass cutting....

    i recently downloaded and now a 1/8 cut is cut in one pass causing a lot of vibration is this the new norm and is this going to damage my cut motor my machine goes out of warranty next month
Results 1 to 7 of 7