Hi Steve,
The stepover amount is determined by the Quality setting chosen when uploading to the Memory Card.
Here are the approximate stepover percentages:
Draft: 16.6%
Normal: 12.5%...
Type: Posts; User: mtylerfl; Keyword(s):
Hi Steve,
The stepover amount is determined by the Quality setting chosen when uploading to the Memory Card.
Here are the approximate stepover percentages:
Draft: 16.6%
Normal: 12.5%...
Perhaps, but nevertheless, there is an Offset of the bit that assures the complete pattern is carved. Steep-walled/deep edges can still have some “bit-chew” from the wider diameter of the bit. Some...
Did you also set your Bit Optimization to BEST? That setting should apply an offset to the bit to allow for the 7-degree taper to not cut into the pattern. This is especially important for Pierced...
Looks great, Sharon! I could use your help too.