Search:

Type: Posts; User: erick3525; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    31
    Views
    14,032

    I am located in the Dayton, Ohio area. For...

    I am located in the Dayton, Ohio area.

    For certain projects, Designer can be a quick easy solution. That's why I want to keep an actual CW in my shop. Then there are times that I want to do...
  2. Replies
    31
    Views
    14,032

    At least there isn't anything to restrict using...

    At least there isn't anything to restrict using the card from my old machine for the new(ish) one. The new machine was almost spotless inside...aside from being stuffed full of packing peanuts...and...
  3. Replies
    31
    Views
    14,032

    Not sure if anyone is still following this...

    Not sure if anyone is still following this thread.

    Anyway, I recently had a component failure and with LHR apparently out for the holiday I decided to look for other sources of parts. Again, I...
  4. Replies
    31
    Views
    14,032

    A quick response to the "Sarcasm of Open Source /...

    A quick response to the "Sarcasm of Open Source / LHR": For a quick, basic project, a close to stock CW would be the simple solution. For a project with special considerations such as a desire for...
  5. Replies
    31
    Views
    14,032

    Could compensate for backlash in the CNC software...

    Could compensate for backlash in the CNC software which to me is much simpler than writing code. I have no intention to develop my own software when there is well established opensource software for...
  6. Replies
    31
    Views
    14,032

    Stepper motors would be an option, but not as...

    Stepper motors would be an option, but not as clean as just using the original servo motors. The table on my CNC'd mill uses pretty stout nema 23 steppers without gear reduction to drive a heavy...
  7. Replies
    31
    Views
    14,032

    According to the quote you responded to, LHR...

    According to the quote you responded to, LHR related their software to proprietary operating systems and the poster was only repeating it. Also, according to the poster, the statement made by LHR at...
  8. Replies
    31
    Views
    14,032

    Sorry for "kicking the dog". My interest in...

    Sorry for "kicking the dog". My interest in converting a CW at some point to LinuxCNC is to add functionality and my original and continuing interest in the CW is for a lightweight belt fed CNC with...
  9. Replies
    21
    Views
    4,277

    I found a 1 meter long ribbon cable so that I...

    I found a 1 meter long ribbon cable so that I could relocate the LCD Keypad where I want. The downside is I had to buy a bundle of them so I now have a few extras. If anyone is interested, I have a...
  10. Replies
    31
    Views
    14,032

    Extra Long LCD Keypad Ribbon Cables for sale

    I have reconfigured my Carvewright for what suits me best, and I wanted to relocate the LCD and keypad. Unfortunately, the stock ribbon cable isn't long enough to give many options. I found 1 meter...
Results 1 to 10 of 10