Search:

Does 2.005 include any features that allow demo mode for rotary carving, or is that feature totally contained in the rotary jig accompanying software? I played with demo mode of the 3d suite for a...

I've developed an interest in 3D printing recently, gained thru the kickstarter Peachy Printer project. As I explored other presently available 3D printers, I saw a likeness, to a large extent, to...

I have been silent for several weeks about the rotary jig II that I built. Previously, a problem occurred when I tried to initiate a carve operation. I never was able to have the board edge sensor...

Dan,
I haven't said much on this topic recently, since I am awaiting delivery of the bearings. I have installed the jig into the CV and learned what various operations are performed. However, I need...

Well Dan, I have the jig built, except for bearings, which I found listed at Grainger's, and the three springs. On the roller lifter, I see a spring under the top concave portion. The spring portion...

I, to have made peppermills, but on the lathe. however none look as spectacular as the one you have shown. I hope I can become adept enough to do something as nice, once I figure the Jig operation...

I have been busy carving Dan's Rotary Jig II. I have yet to figure out how it all works, even after I get it assembled. There are a few items that, although are shown in the photos, are not obvious...

I have a problem where the measured board length is consistent, but wrong. I always make my boards extra long to stay under the rollers, but if I insert a 17" board and initiate a project, the board...

I have been making lathe turned pens for several years and have always wanted to engrave them. Laser engraving is way beyond my budget. However, the Baker Rotary jig may do the trick, if it can be...

Thanks Al,
That was something I intended on trying.

I make turned pens from wood and managed to find a pair of carved pen boxes in the free pattern category. However, when I try to upload either of these patterns, Designer software shows a compile...

Your tutorial on Blender for Carvewright is fascinating, but I have a Blender version 2.6x. Obviously, the tutorial shows very different screens and shortcuts than my version does. Has the tutorial...