had the same problem as you and bypassing the switch solved the problem. my thanks to you.
Type: Posts; User: pterris; Keyword(s):
had the same problem as you and bypassing the switch solved the problem. my thanks to you.
message "please close cover" won't go away. checked switches, blowed all dust from unit, pluged and unpluged switch going to ckt. board, still can't get past "please close cover".:cry: what next?
Any one have a 3-d of a cupcake?
put new board in with no holes, but truck will not move past middle of track. I can shut power off and manually move truck to left but when manually moving truck to right it jams about midway .
When loading a board to carve, the machine was going through its measuring cycle and when the bit holder was measuring the width of the board it encountered a hole in the board that I should have...
My machine had been working fine until today when attempting to carve a new design onto a 12x16 x 1 inch thick foam board (hdu), the carving bit moved to the start point of the piece and immediately...
while removing the cover of my machine to check wiring attachments I discovered this thing next to my machine. It must have came off the machine, but I have no idea what its for or where it goes. ...
This may be handy for some applications
wrench is very impressive. more good ideas on this forum then imaginable. I am overwhelmed with the possibilities of this machine.
thanks to rick devine for the pdf file to trim the sweeper. that did the job for me. :D
Can you hear my machine carving in the background? Problem was led contrast control was to far clockwise fading out the text on the led. rotating led control counter clockwise allowed text to show...
memory card was empty and not fully inserted when i first turned machine on. when led did not light up I loaded a file on the memory card and inserted it correctly in the machine. still no led .???
can't get the led to come on. went through the quick start procedure, inserted the memory card, pluged in, turned switch on, nothing. what have I overlooked??? :roll: