Great idea on ordering another wire, I'll definitely look into that.
As for cleaning the lens, I do take them out and clean them but noticed they get scuffed and scraped over time so I kept an old...
Type: Posts; User: Rob Mulgrew; Keyword(s):
Great idea on ordering another wire, I'll definitely look into that.
As for cleaning the lens, I do take them out and clean them but noticed they get scuffed and scraped over time so I kept an old...
Hey Al,
I checked the board sensor reading with white paper and it now reads at 77. I realize that's quite low and I'm going to order a new board sensor but at least its good to know you can run...
Would it make sense to have an option to not even use the board sensor? I can measure my work piece accurately and tell the machine where the center of the project is. I'm really just thinking out...
I didn't even realize that C6 was gone too. Honestly nothing touched any pieces on the circuit board when installing this. I'm not sure why the pieces would fall off or where the other one (c6)...
78223
Bottom left is where the solder was applied. As for the piece that was there I accidently blew it somewhere off the table with the air hose and it will most likely never be found again. ...
Hello,
After putting in a new board sensor recently I have been getting low readings and eventually it went to a “0” reading and wouldn’t work at all. I took out the board sensor and the lens...