Search:

Type: Posts; User: gbrlbll; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    1,248

    Just to provide an update, Joe Lovchik did...

    Just to provide an update,

    Joe Lovchik did call me and leave me a voicemail informing me that a shipment of cut motors had come in. I returned the call and spoke to Chris who said that they...
  2. Replies
    6
    Views
    647

    A community member was able to sell me a new case...

    A community member was able to sell me a new case and shipped it very quickly. Got me carving again in no time! Thanks all for the help
  3. Replies
    2
    Views
    1,248

    Service department????

    LHR is your ever reading this I want you to know how disappointed I am with your service. Ive not had much issue with my carvewright or even your service department in the 2 years of owning my...
  4. Replies
    6
    Views
    647

    Im in serious need of a cut motor. Worn out...

    Im in serious need of a cut motor. Worn out one with good housing , or good working cut motor. LHR is out of stock with no anticipation date for new stock. If you have one to sell please...
  5. Replies
    6
    Views
    647

    Yep, already sold

    Yep, already sold
  6. Replies
    8
    Views
    806

    Also as a side thought.... My CW is ridden...

    Also as a side thought....

    My CW is ridden hard and put away wet, runs long n dirty and has never given me too much fuss. So I am not that disgruntled about it, it really doesnt owe me a darn...
  7. Replies
    8
    Views
    806

    Same for me Yes DC Tried cutting acrylic...

    Same for me

    Yes DC

    Tried cutting acrylic once a long time ago(maybe hour 30-40), didnt end well so I never tried again.

    Nothing attached to muffler

    Only a little dust pack in the center...
  8. Replies
    6
    Views
    647

    WTB: Worn out cut motor

    Looking to buy one or two worn out cut motors. Really just need the plastic housing but dont mind buying the whole thing just to have some extra parts on hand. Does not need to be running!
    ...
  9. Replies
    8
    Views
    806

    How did this happen? Motor brush melted

    Came out to the wonderful smell of melted plastic and electricity to find a partially finished carved :(

    Upon investigation I determined the cut motor was seized up. Expecting to find bad bearings...
  10. Replies
    7
    Views
    675

    Wasnt exactly what I was looking for, but thank...

    Wasnt exactly what I was looking for, but thank you!
  11. Replies
    7
    Views
    675

    Need simple column

    Hello carvers!

    Need some help finding a pattern for a simple column. Just a smooth even column no flutes or tapers. I want to carve them into the left and right stiles of a corner cabinet, .75...
  12. Replies
    5
    Views
    524

    Took off side side covers, and bottom cover. ...

    Took off side side covers, and bottom cover. Cleaned all the screws and gears really well, then regreased with fresh lithium goo. Manually raised and lowered head with jack hole to work in grease....
  13. Replies
    5
    Views
    524

    Head stuck, wont crank up or down.

    So my head is stuck and wont raise or lower on my carvewrightx. Head is about midway in height so no its not raised to high. Start working my way through some trouble shooting steps and begin the...
Results 1 to 13 of 13