Search:

Hello all,

My wife and I are expecting our first kid next month, and the writing's on the wall for me and hobby time - plus the extra cash would help us now. So my CX, bought 18 months ago, with...

Someone was nice enough to PM me an alternate location to buy one with sane shipping prices.

Lynn, maybe instead of snarky replies, you guys might consider that if you're getting lots of...

Edit - Found one elsewhere online, all set now!

I messed up and forgot to add a split collet to my order when I bought a decorative bit with a 1/4" shaft. Went back to buy it, and LHR wants $12...

We might have a winner. I found that the end that goes into the chuck was able to be pulled off. I will have to go grab some epoxy tomorrow and reattach it. Thank you all for the suggestions!

I just pulled it all the way out and the squared off end sections are the same length - I'm assuming this is correct, or are they supposed to be different?

30 Minutes East of Concord, NH (03037). I know according to the Start U website there's no one within 100 miles :-(

A logical answer, but that doesn't seem to be it.

I took off the back cover and removed several of the screws around the motor near where the flex shaft protrudes. I've pulled and pushed as hard...

I have 13 hours cutting time on my carvewright -

Spent the last 3 hours trying to do one carve. First I spent an hour getting the head pressure up, lube and readjust posts didn't help, read on...

Thank you, that did the trick.

Working on a design - Have a part I created that I need to carve 3 times, one of them at a 90 degree angle to the other three. Then they get glued together for strength. For some reason, Designer...