Search:

Bob,

Welcome back to the forum and good to know you are feeling better. Looking forward to seeing your work.

You have done a great job and your wife should be very pleased with your results. It is an eye catcher for sure!

There are known issues with the Mac, your best bet is to call CarveWright to get the latest updates with what is going on and support for your issues.

Yes you can raise the head up. Since it stalled the machine the project has stopped so you can not resume at the place it stopped.

Depending on what type of project design it is you can modify the...

Look to see if the board is jammed up in the machine. Verify that the sliding plate is not pushed up tight against the board preventing it from moving in the machine, the board is not tapered and...

Glad that worked for you.

Well done! Waiting to see the finished project!

See if you can make the pattern now. I regrouped everything into one group. I think your problems was all of the different groups. I did need to change the setting on the inner circle to merge...

Your pictures do not show up..

To "make pattern" you do not use the "extract pattern" tool. That tool will copy all of the patterns on a project board and place them into your library.

To make a pattern, select all elements...

Mike's post is the most common cause for the truck not moving far enough to push the bit plate out for the bit touch off. Also check that the Y rails and bearings are clean and lubed, no dust build...

Dick,

No problem! The main point is YOU NEED DUST COLLECTION! You can make your own or go with one that has been proven to work.. IT JUST SUCKS! ;)

It looks like you missed down loading the cover modification and installation instructions from the link in your order email.. No worries here is a link to it...
...

Happy Thanksgiving to you Oscar and everyone else!

Most will say no it is not safe to vacuum out the machine with a shop vac as that shock you got is static discharge. It can discharge to electrical components and kill them.

Your best bet is to...

Is the bit touching off correctly on the bit plate and the top of the board surface?

Draw your design using the drawing tools and then assign your bit of choice to the lines/vectors.

Import and image for tracing, draw your lines.

You can also import a DXF file and then assign...

If you can export the image out of the PDF file then you can import the image into Designer. There are programs that will convert PDF images into vectors that then can be saved as DXF files. Then you...

The only thing that I have referenced for resistors is the color coding like in the link I posted.

Maybe DigitalAl will jump in.. I will send a note to him for his input...

This should help..... https://www.electronics-tutorials.ws/resistor/res_2.html

I would say no you do not.

Lower the head down so that it is about 3" below the flats on the corner post. Then measure from the top of the head to the lower flat shoulder. You only need to measure on the right side (clear...

Great job in tracking down the problem.

Check your head pressure, remove the cover for the X gears and inspect the gear teeth. run the X axis test with the gear cover off.

Give CarveWright a call...