Search:

Hi dragonsair, I have a similar problem. What I have found is the FFC cable connection to the Z board on MY machine is very very sensitive. Both are new, but even sitting for a week I can get a...

It would be great if that was the problem. It is not. Pulled the bottom cover this evening and did some testing. No 24V coming from the power supply :(. Looks like the smoke escaped.
Maybe the...

New A2060 board arrived. Prechecked the continuity - all paths good. Installed, turned on machine. Same error. No power to the Z axis motor. The problem has to be further upstream from A2060. ...

Update on my machine for Gumbo. I pulled the FFC and brought out my multimeter. All the pathways tested good. But, I see the ribbon from the factory was folded once, unfolded, then refolded at a...

Gumbo,

I essentially have the same problem that occurred nearly the same way and now my machine is stuck on the Z stall error E06 0313.
Mine happened about 1 hour into the first carve after...

I am working on the machine now for a Z stall problem. I do not see where these small pieces might have been attached to any of the visible plastic components.

Thank you for the responses. I can see two of those alignment tabs are still in place. I have to pull out the machine, raise the head and get a better look
to see if all are present. Will...

First post. All my other questions I have found answers with the search function or reading the PDF files.
Until today.


I bought my C machine some 5 plus years ago. On sale and it came with...

I have been watching this product over the past 5 years. Reading the forums, in particular the posts on mechanical and software issues. I figured the the 'c' version was a good point to jump into...