Search:

How do you get the basic patterns restored seems I have lost them somewhere along the way

It did take 93/128 thanks for the help

No I do not see it

I do not know why it will not take the decimal point when I press it on the machine keypad

Each time I enter .725 it defaults to .727 also when trying to enter in machine when prompted for board thickness I try to enter 0.723 it just gives me 723 instead of .723 also I I try to measure...

I did enter .723 as board thickness when setting up the project

I am running a project with board dimensions 28" long 14.5" wide and .723 thick. When starting it ask me to enter board thickness when I try to enter .723 it will not take it. Does anyone know how to...

I am using the bits that have been pressed into a 1\2" adapter by carvewright. Guess I will just have to remember to add a backer board when carving 1/2" stock.

Board setting for 1/2". There should be someway to get it back in calibration.

Well this is enough to make a man cuss. After repeated disassembly cleaning checking. I used double sided tape to attach a 1/4" piece of wood to the back of the piece I wanted to carve. It ran with...

I put in a board that is 1/2" thick and found the difference between touching the plate and the board surface to be off by .133 instead of the difference being .5 it is .633 Also same problem with...

Doing a sensor check on zAxis 1st time -0.035 top 2.925 bottom done with 1/8" cutting bit.
2nd time -0.032 top 2.924 bottom
...

62339623406234162342Here are some images of the cable, encoder, and plate that bit touches on. Will the cover have to be on and everything closed up to do the test?

I think the problem is before it gets to board thickness measurement. I have 160 hrs on the machine. the ribbon cable has a few wrinkled places in it. I will check the encoder.

I checked the plate where the tool tip touches down and there is no hole there. The problem is the same with 1/8" cutting and 1\16" carving. It dose have the ROCK chuck. would recalibrateing the...

getting z axis stall when bit touches down on plate beside brass roller. Using version 1.187. Have made sure z truck moves smoothly up and down and is attached to the belt firmly by the 2 screws....

thanks for the help

I have been trying to get a good pattern for a scottish rites eagle. The the body comes out fine but I am having problems with the head and the feet and crown. Any ideas on solving this problem. The...

I have tried a number of different tool lengths from 1 3/8" - 1 1/2".

I added a rock chuck to my machine and I can not get it to recalibrate. I downloaded the instructions and when I get to the point where the 3/8" bit is suppose to drop in the hole in the squaring...

Thanks I will give that a try. Has anyone used the dust collector listed under projects on the CarveWright web page?

Yes the head of the screw in still in the z-truck and the rest of the screw is in the bearing. It broke off fairly flush with the bearing. I have been able to drill a small hole in the screw. When I...

:confused:I was about 96% complete with a project when the left bottom roller bearing broke off the z-truck. the manual says to drill out the screw head to get it out. How do you get the rest of the...