Search:

Type: Posts; User: Ilonaco; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,423

    I used photoshop and photoshop essentials to...

    I used photoshop and photoshop essentials to "even out the lights and darks so the range was narrower. On the dark areas, I lighten them a LOT. By making the blacks greys, it doesn't cut so deep. ...
  2. Replies
    52
    Views
    24,135

    Highdet, I just put 2.0 on two machines. You...

    Highdet, I just put 2.0 on two machines. You have to license the program to two specific computers, but they allow the software on two computers. I already did it so I know it's true.
  3. Replies
    71
    Views
    19,607

    My flex heated up because the bearings went out...

    My flex heated up because the bearings went out in the head that rotates the bit. It caused the motor to work harder and put strain on the shaft. I replaced the head and problem solved.
  4. Replies
    52
    Views
    24,135

    CW allows the software to be placed on two...

    CW allows the software to be placed on two computers. I've done it for a few years now.
  5. Replies
    19
    Views
    9,915

    I bought the last one Ed had made about a month...

    I bought the last one Ed had made about a month ago. It really works well.
  6. Replies
    29
    Views
    15,767

    That works fine Morton. I do that all the time.

    That works fine Morton. I do that all the time.
  7. Replies
    19
    Views
    9,915

    Does anyone know where I can buy a rotary jig. I...

    Does anyone know where I can buy a rotary jig. I could not find them on the Carvewrite website, nor ebay
  8. Replies
    69
    Views
    15,437

    It will also heat up when the bearings start to...

    It will also heat up when the bearings start to go in the carriage because it has to work so hard.
  9. Thread: Sled problem

    by Ilonaco
    Replies
    40
    Views
    9,539

    I use a sled and hot glue 4 inches on each end so...

    I use a sled and hot glue 4 inches on each end so I don't waste any wood. Works fine if the rails are good.
  10. Thread: Sled problem

    by Ilonaco
    Replies
    40
    Views
    9,539

    I like to use a sled with absolute straight...

    I like to use a sled with absolute straight hardwood runners and masking tape on the bottom of the side that goes over the brass. That and the two support rollers from Harbor Frieght solved this...
  11. Replies
    31
    Views
    48,119

    I just happened on your post. I do the same...

    I just happened on your post. I do the same thing using a spindlel sander. I'd be interested in seeing your prototype when you get it finished.
    Thanks
    Dominic Bruno
    Land O Lakes FL.
  12. Replies
    10
    Views
    3,491

    My problem was just the opposite. I have been...

    My problem was just the opposite. I have been using my CW a week. I found problems when I tried to seat the 1/16th carving bit. The holders were "dinged" when I received them from CW. I bought...
  13. Replies
    7
    Views
    3,797

    My Carvewright also had a roller break

    I had my machine a week. A couple of the bit holders had "nicks" in them when they arrived. It looks like the 1/16th carving bit drove straight down and when the head moved it snapped off the...
Results 1 to 13 of 13