Search:

I just added three patterns to my pattern library. I can load them in from the designer software. However when I try to load them into my pattern editor (I have the license), I can't find them...

I had a paper covering the insides of the machine. But this screw went down inside the section under the keypad. The magnet wasn't strong enough on my screwdriver, and it let go and the screw went...

Thanks for the info. Mine is a "c" machine. Are things about the same??

I watched the video several times, and then removed the top of the Carvewright just as indicated. (Did lose one screw in the process). After I adjusted the carvetight truck, I put everything back...

It wouldn't let me post the pictures. Said I didn't have permission to post them. New problem this AM. When I turned the machine on, I couldn't read the display. Tried changing the contrast,...

Can you remember what the solution was? That's about the vintage of my machine -- could be a machine problem or a software problem.

Not sure what you mean by adding draft. I usually only get to work on my wood projects over the weekend, that's why I haven't replied. I'll try to take a picture of one of my carvings along with...

I only get good carvings of words and phrases about half the time. Most of the time, the letters have parts missing, even though they look fine on the screen. I thought the problem might have been...

Thank you very much. This will work.

I bought the soccer player pattern from Carvewright pattern store. The figure was for a picture frame and didn't have a face. I am looking for a pattern of a boy soccer player complete (with a face,...

This may sound angry, but I have spent about $500.00 in the last year or so for program add -ons, (editing program, sculptor program), upgrade to Designer 2 (which I only had for about six months...

I registered my new designer 3.0 software and updated my licenses. Opened designer 3.0 as administrator. When I tried to do some of the features, it said I couldn't save it because I was in demo...

Thanks for all the help. The carving I was doing took just under four hours to complete, but it was the original size. Will try the suggestions -- they are good ones. I remember from when I first...

This still begs the questions as to why it doesn't measure correctly from the project menu, but I just loaded the board, measured it with #7 and length. It came back with the correct length. I then...

I actually took the board out, shut the machine off. Waited 10 seconds and turned it back on. It did the same thing. This only started doing this recently. I had some problems with the truck...

The width is 11 1/8 ". When it scales the design, it pretty much keeps the aspect ratio, although they tend to be just a bit longer in proportion than the original design. I have tried both with...

It says 12 and some decimal fraction (can't remember exactly) even though the board is 36" long. If I try to carve it, it will carve a much reduced design than if It had come back with the 36" inch...

I have been having trouble lately with measuring the length of boards. When I load -say a 3' board and push #7 -- "measure board" the measurement comes back exactly correct. However, with the same...

You mention taking the board sensor off and cleaning the lenses. I can't even find the board sensor. Where in Hades is the thing located? I can't tell from the manual, but everybody else seems to...

Looks like it might work. Guess I was trying for too much detail. Took a photo of my St. Francis statue in my rose garden and tried to digitize it. It didn't have enough contrasting colors but had...

Tried a number of ways to carve St. Francis. Always come up with some part that isn't right. Only success was with a cartoon one. Anyone know of a commercial pattern I can purchase of St....