Search:

I just went through doing a two sided carve with a two sided mpc on the UCB and it went fine. I put the board around the middle of the carrier. When I flipped it, I put it in a slightly different...

I think your problems have more to do with getting the UCB working right than to do with two sided carving. For example, having the carrier roll out of the machine is because the roller did not click...

That sounds like a pretty good method. I think that, however, since the numbers are relative to each board measurement, it cannot be any more accurate than using place on center. I have also used the...

Whenever you carve a board on the UCB, you have to first go through the UCB measuring procedure. This also applies to when you flip the board over on the UCB.

When the machine prompts to flip the...

Prompting for the bit over and over could be because the head was not clamped completely down before the touch.

You should be able to flip the board on the carrier, let the machine remeasure the board exactly as you did for the back side, clamp down the head, and away it should go. It should know where to...

I have not tried to do a double sided carve using the USB and a double sided mpc. (I do double sided carving differently.) I do not, however, see any reason why it should not have worked. The second...