Search:

Type: Posts; User: jbrunot01; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    3,092

    Yep... You called it EXACTLY... I pulled the...

    Yep... You called it EXACTLY... I pulled the board last night and sure enough on of the wires on the large capacitor had broken away from its solder socket! I just bought that board 6 months ago...
  2. Replies
    8
    Views
    3,092

    I'm going to have a look at that tonight. I...

    I'm going to have a look at that tonight.

    I just recently bought a new one from them because I couldn't get the CUT MOTOR to start up - Now I cant get it to turn off.. LOL
  3. Replies
    8
    Views
    3,092

    I've got a note into them... We'll see.. ...

    I've got a note into them... We'll see.. Thanks.

    The machine is about 5 years old. I did by-pass the safety switches, but it's been running fine for years like that.
  4. Replies
    8
    Views
    3,092

    Cut motor runs continuously

    Even BEFORE I load a project - like right when I turn the power switch on...

    The CUT MOTOR come alive.

    WTF???

    Jeff Brunot
    Marietta, Ga
  5. Replies
    4
    Views
    2,060

    Sparking Motor Brushes

    I just replaced the cut motor brushes...

    Started a new carve project and smelled something burning...

    Looked thru the small vent slots on the cut motor housing and found that there were sparks...
  6. Replies
    8
    Views
    17,721

    I just replaced my Carve-Tight Spindle too. Put...

    I just replaced my Carve-Tight Spindle too. Put the new one in last evening... AGAIN... NO WASHER WITH THE KIT. My new Z truck did not have the tapper and the screws were not PHILLIPS HEAD. They...
  7. shopping now for a small dia. carbide bit.

    shopping now for a small dia. carbide bit.
  8. I tried that. I think the machine screw is...

    I tried that. I think the machine screw is pretty hard material. I was able to make a small divit in the good end, but unable to drill through or get the threads to turn themselves out.
  9. CT - sheared the bit locking bolt in the spindle

    So I went to remove a 60 deg V bit so I could install my carving bit... placed the T handle in the socket screw - went to back the bolt out and it sheared off. Broke about 1/2 down the length. The...
  10. Replies
    6
    Views
    2,169

    Maximum Pass Depth???

    Does anyone else have this problem...

    When I go to use the CUT PATH TOOL - A dialog box opens called CUT OUT CONTROL...

    Down at the bottom is a field where you should be able to enter "Max Pass...
  11. I foung one brush was bad / melted... It was the...

    I foung one brush was bad / melted... It was the one on the bottom of motor. The side w/ the rectangular air port. Not the side with the RPM Sensor board.
  12. cut motor slowed - then quit

    jeff brunot - marietta , Ga
    my motor started slowing down then quit too. not sure what's going on.

    I guess I'll check the brushes. where is this x-board located?
    jeff
  13. Hi Bruce - Jeff here - over in Marietta. ...

    Hi Bruce -

    Jeff here - over in Marietta.

    I've had my machine for 6 mo now. I've been pumping out lots of work. Had a gteat weekend up at the Marietta Square Artists Market. Sold lots of...
Results 1 to 13 of 13