Search:

Well with 15 yrs in the milling of tool and die I only post what I see when I make the mods to my unit I will post them and lets see who has a better Idea on whats going on inside.

I have found that this is caused by the y trunk does not move the arm on right to move into place for measurement. This could be caused by dirty rails or motor is loosing strength to move arm or y...

The problem sounds the same the machine has lost home everyone must check the left side where home is you need a lite to see if home has a small hole punched in it my machine had the problem you need...

Here is a new problem machine would cut fine and cut board to size then all of a sudden the machine wants to cut too deep noticed tool is cutting guide rod below rollers at first I thought board was...

Sears also has tool holders 1/4 and 1/2 part#
926695 and 926694 same tool holder used on other routers.

I called I emailed and still no one is home tool bits are standard as long as the shank and leanth is close but what I want is to buy a probe the way I see it if they can't meet supply and demand...