Search:

Everything is explained better in this post in the Announcement section, IMHO.

http://forum.carvewright.com/showthread.php?p=95814#post95814

You don't check the cars you buy before you test drive them?

Has anyone ever stopped to think that maybe, over time, that the lubrication could have possibly dried???

I mean, I seriously doubt that the machines come straight from the factory to us. If that...

Let's not forget about their cousin, the dilliwhopper!

Here is one of the newest ones. Haven't carved it yet, but some of the old-school gamers will recognize it. :)

bob,

Each web translator sight is going to read the information differently. I haven't tried using babelfish yet, but will give it a shot.

CNS those look great and so does the project. Im sure your niece will love it. I have always wondered if the machine would be capable of braille. Now we know.

Quando lei il colpetto la sua asse, lei deve il colpetto esso verso lo schermo di visualizzatore a cristalli liquidi. Fare non il colpetto che finisce sopra la fine o il suo tagliare sarà gettato via.

Lei è corretto. Lei dovrà aggiungere 8,9 cm alla sinistra e la destra. 8,9 è il minimo.

gcioffi,

Lei ha scelto all'autojig nel software? Se così, scalerà il progetto sulla macchina.

Lei dovrà aggiungere che alla lunghezza dell'asse. 8,9 cm a entrambe le fini.

there are several free translators on the web that you can use. I simply typed in the information in english and translated it into italian. One site that i find useful is www.freetranslation.com. ...

Maybe that will help explain.

Per reprimere il progetto da restringere quando lei sceglie di stare sotto i rulli, lei deve aggiungere almeno 8,89 cm all'asse che lei colloca nella macchina. Così, se il suo progetto è 12 cm nella...

The cut depth of the software was reduced from one inch to .8 inches to help avoid issues that could occur during carving. The actual cut-path was not changed. It will still cut through items 1...

how about smiter-man???

the port is specifically for calibration at the factory or so they say.....

you could also get the vibration noise if you dont have flexshaft fully inserted into the z-truck assembly. When it is not fully inserted, it will pull out of the z-truck while carving and tear up...

ron exactly what was you doin when it broke your bit? did you machine stall? did it dive or plunge into the wood?

danny, they have not said anythign about when the machine will be available to the canadian market. just keep checking their website.

check to make sure that you dont have any dust in the slot for the card. it only takes a small amount of dust to break the connection on the machine. Also make sure the card is fully seated before...

Hey, Im an Okie and am in need of a Oklahoma State Cowboys logo (either the mascot or the letters) for a christmas gift for a major OSU fan. Can anyone give me a helping hand with this? It would...

jenny the memory card saves both sides of the project at one time so you don't have to worry about this. the machine will prompt you to flip the board when it is ready to carve the design on the...

hey folks, here is a new pattern i created from a coloring book scan. Its not great but its better than what i have previously done. tell me what you think.

ken, where does that pipe run to? you gotta have it vented somewhere. and how do you clean it out? Im sure that you get some type of debris build up in it.