It has happened again (twice). I have the carvewright boxed up and ready to ship back to you. I have had multiple problems and it is being returned to the shop. Thanks for checking up.
Type: Posts; User: mailman; Keyword(s):
It has happened again (twice). I have the carvewright boxed up and ready to ship back to you. I have had multiple problems and it is being returned to the shop. Thanks for checking up.
I use a router table like the one on "The Router Workshop" and there is a slot on one side of the table to make a drawer to hold router bits. After I received my router table, I went through the...
I was needing some knobs for a dovetail jig and thought this might be a good project for the carvewright. This is my first try at making patterns, so be kind to me. This is a good project for a...
Just a tip in case someone is having problems finding a brass brush to clean up their carvings, I found some at Walmart. They were in the same section as masking tape, glue & caulk. They were 3 to...
The board is flat and there are 2 knots in it, but they are smooth with the level of the board. They are not loose.
The long side of the box (at the bottom of the picture) was the first piece...
I was carving the jewelry box that was entered on the forum by yenne (I thank yenne for that too) and was carving two sides and one end on a single piece of wood. After the machine stopped after...
I wish I knew the answer to your question pkunk so you would get an answer. I have been watching your question for the last day or so and wish someone would give you the correct answer. This is a...
I appreciate the tips. I took the flexshaft out from the cutter head and then pulled it out of the insulation and about a foot of the cable come out. The cable had burned into. I called the...
My carvewright just arrived today and I was carving a 2 inch circle all the way through a 3/4 pine board and I noticed smoke coming from the flexshaft (in the bend from the machine to the cutting...
DHL just left after delivering my carvewright machine. I have it unpacked and am reading instruction manual again ( I downloaded the one off Carvewright homepage and have read it over and over) and...
Britt, I want to add my thanks to the list. This should be a terrific idea for us that don't know what we are doing. I am expecting my CW any day now. Close to 3 weeks and I am getting very...
Terrific job! I can't wait til I get my machine.
Nice job! Looks like you are a pro already.
Hopefully you just added this to the downloads section. This was the first place I looked and I don't think it was there when I looked. I do appreciate you telling me where the manual is. I have...
I have looked around the website but I do not see anything about downloading a manual. I would appreciate it if you would direct me to the download.
thanks
Hi just ordered a CarveWiright and cant wait to put it to the test. I am ready to start work with it tomorrow (to bad I was told it would take a couple of weeks to get the machine). I know I will...