Works great, exactly what I wanted!
Thanks
Peter R
Type: Posts; User: Rocky3213; Keyword(s):
Works great, exactly what I wanted!
Thanks
Peter R
My software is too old for this file. I guess I have to upgrade.
Thanks
Sounds right. I'll try it.
Thanks
How do you make a ring to place on your carve region, so that the inside and outside of ring are at carve region height?
The mold will stay under the very thin upholstery leather forever. There will be no tooling other than forming and gluing the leather around the mold.
I need some suggestions on what to make mold from. I'm have made a Mustang horse emblem that will be covered with leather by my custom car upholsterer so that the emblem looks as if carved into the...
Sharon...Cut path was easy to understand. I still don't understand how board thickness works. If the top of the pattern is close to the top of the board, then why are the legs too thin? It's like the...
SharonB,
I found my problem. My board was too thick and I needed to check the "pierced" box in both pattern and carve region. I'm posting here because I could not figure out how to post a picture on...
I'm in Lowell, Or. I've not used my machine in a few years and need some help now and then. 5 minutes on the phone could save me hours.
I've made pistol grips in the past and now plan to diversify....
38568 I think I've added the file that shows the disproportionate skinny legs. I've had a dozen tries on this, my first, project. A little discouraged so I took a couple days off.
I'm using a free pattern of a rearing horse. I've reduced it's size to about 1.5" tall, I've set the height to 25. Regardless of any settings I can find (height & draft), the legs are thinner than...
I'm interested in 1/16 carving bits but I have a new machine and don't use QC's. Will these work? I don't understand "PM replies/orders/confirmations". I'm too new and dense as well.
Rocky
I found the problem only to discover another. The problem cause came to me in the middle of the night. My project piece was 1/16 higher than my sled. When the piece went under the overhead roller the...
Can anyone tell me what causes strips of different depths? Some passes of the cutter are a little deeper than they should be. In the photo, the bottom is the start of the pattern. A strip showed up...
Ron & Mary,
Just received my CarveWright Wednesday and my first project is grips for a SAA Colt. I've done a scan but I'm still working on the design. Any advice or help would be appritiated.
...