Search:

I am still looking for someone to help me with a pattern for the arm and chalice image I posted a few days ago. Any help would be appreciated. If there is a different area of the site I should post ...

Thank you, Bud. That looks like it will work perfectly.

rkm,

Great work. Do you have anymore heraldic patterns you're willng to sell or share? Specifically, I am doing a project for a friend with his family's coat of arms and need an arm holding a...

Anyone have any suggestions for me?

46122461214612246121 Did this work? I am using the 'Insert Image' button. Even on my last post I can click on the attachment button and they still show. When I try to use the 'Attachments' feature it...

Hello, Everyone

I check in here often for new ideas and inspiration, so thank you to all who contribute for the benefit of us others. I am doing a humidor for a friend themed to his family coat...

I will take a look. Thank you.

Does anyone know of any Dallas Cowboys patterns out there for share or purchase? I am not a fan, but doing a project for someone who is. Thanks!

I received my replacement QC from SEARS, having thoroughly explained what happened on the first order, and it is the same part as they sent me the first time with the extended collar. I don't know if...

New chuck broke! Rock, here I come!

I ground down the collar on the new QC as suggested, reinstalled it, and the machine runs beautifully again (after tightening up the Z truck which was apparently loosened by all the vibration from my...

That seems like a logical answer. Dang! The PN I have is A005-00033. Are you saying this is correct, but they sent a similar chuck meant for a different tool, or do I need a different PN for the...

I have had my eye on the Rock Chuck. It is just hard to justify while I have free replacement of the QC for four more years and it has given me no other issue until this one gave out. Anybody have...

I recently had to replace my QC because it would no longer accept new bits. There were no other probems with the machine at the time except for this specific issue. My replacement QC arrived from...

It's been a very busy week but I did have enough time to get out to the machine and do a little troubleshooting. I started with a thorough visual inspection of the chuck and rails, and right away...

Thanks for all the suggestions. I hope to dig into the problem tomorrow further with our discussion in mind and will be back with the results.

Is there a specific process for evaluating these areas? Reasoning leads me back to the fact that the machine executed a complex carving with no loss of detail or resolution, and only gave me this...

This is exactly what it does. The machine will cycle through the homing process, then ask me to insert the bit I just did before cycling through again. I should have some time tonight/tomorrow to...

Thank you each for your replies. An improperly seated bit was my first suspicion; however, I never had a problem like this with my first machine and exchanged bits many times without issue just as I...

I just received my second CompuCarve machine after the cut motor on the original unit stopped engaging. This happened within four weeks of purchasing it through SEARS, where I opted for the 5 year...