I've spent an hour rearranging my icons on Desiner pro 3. I've made sure I have no new updates. I have also made sure that the reset tool box after closing the program is off as well. Every time I...
Type: Posts; User: dante4488; Keyword(s):
I've spent an hour rearranging my icons on Desiner pro 3. I've made sure I have no new updates. I have also made sure that the reset tool box after closing the program is off as well. Every time I...
Good afternoon everyone, just wanted to see if anyone out there uses a drawing tablet instead of a mouse in the software. I do a lot of tracing/editing and was looking for opinions. I’m not done...
Al, Thank you very much for all the information. I’ll look into all these things that could be the problem(s). I truly feel like you’re trying to help because I would NEVER type that much,lol. I’ll...
There is no hole next to the roller.
When is tries to bob next to the board,right before it’s about to start.
Sent from my iPhone using Tapatalk
Everything checks out with what you both were saying. I did just notice though it’s certain projects that are giving me errors. Does that make sense? I haven’t upload these projects on my card again...
I installed a new z-motor with no problem. Afterwards I did 4 or 5 new cutouts in a sled, like I’ve always done with no problems. Now all of a sudden it measures the board, it asks the general...
I’ve done a number of photos that have turned out just fine. The problem is that when I change the bit optimization to high or best for a split second while it’s optimizing the photo looks the best...
My carving depth is set at .468 on each side. My height on each side is 100%. The Walnut that I’m using is 1.25 thick. I need my final thickness of the carving to come out to .937. I keep getting a...
My machine stopped working in the middle of running a project. I wasn’t by the machine when it stopped, so I calmly walked up to it thinking it was the “check cut motor” but the LCD screen was...
Thank you for the information. The thickness of material is 98% of the time 7/8 thick. I do three - four passes normally because of the shaking I get from the flex shaft. I am just extremely...
I'm cutting 7/8" thick stock. When I try to do it in one pass the flex shaft shakes so badly, even with a new bit. Is it just normal for the flex shaft to shake like that when cutting in one pass? I...
I primarily use my machine for cutouts. It works great but I would like to be able to do it a little faster. The bit I use is the 3/16" cutting bit. I have to do multiple passes in the same area to...
Thank you very much sir. Will try it as soon as I get home.
I will check these parts, but I sure hope not the machine has less than 25hours on it.
I'm using a 3/16" cutting bit. Thank you all your help
No Sir/Ma'am
But please tell me, Even if I did would it have lines like the pic above?
I've used the Bit and cutout a few times with no issues.
Thank you ALL for any info.
I'm using the 3/16 Cutting Bit.
3/16" Cutting bit
I'm doing cutouts, I have the bit run around 3 or more times so I don't try to cut out 13/16" thick lumber all at once. The problem is each cut is a little larger from the last. Meaning if the cut...