That really turned out nice, thanks for sharing.
Type: Posts; User: Sam; Keyword(s):
That really turned out nice, thanks for sharing.
I checked the ribbon cable and it checked out good, is there a way to check the display it self or the electronic box on the bottom?
I will do what is needed to correct this problem, thanks for the input, I will let you know what I come up with.
Thanks guys, I checked the ribbon cable first thing unplugged it and cleaned it up, no issues found, I may have to check a little deeper. The machine still carves with no issues, I just can't see...
While carving a project, I was blowing out the excess saw dust when all of a sudden the machine just stopped, and the LCD was blank. I checked the power to the unit and it was good, so I turned off...
Very nicely done, great job.
Very nicely done, I am looking foreword to cranking one out like that myself.
I think what caused my fault was when I replaced a board sensor awhile back I am sure I pulled on the cabled and cause it to get stuck between the cable channel and the channel cover under the Z...
Had a pinched wire on the board sensor cable, fixed it temporarily, will need to order a cable. Thanks you all very much for the help, it save me down time and money.:D
Thanks you guys for the helpful information, I guess I need to get to work on this, thanks again.
Hi I am Sam, I am trying to fix my machine in hopes of not having to send out any parts for testing. These are the faults I currently have;
1. Please Close Cover-----Replacing switch did not fix...
Hi, I am Sam from El Paso, Texas, the western tip.:D
My software for some unkonwn reason has reverted back to 30 day demo/trial mode and all of my paid for licenses are gone. It is requiring me to register again and I only have the basic program. I...
Hey Guys, I was just wondering could someone tell me, when you are doing a sensor check on the probe, what is the normal reading before you move the probe pointer, is it open or closed? I just...
Called LHR tech, ordered a new probe, thanks again all, for your assistance.
Thanks guys, I really appreciate all your input concerning this matter, I have not called LHR yet but I am about to do so right now, thanks again for all your help. I do have the latest software...
It remained closed when I disconnected both ends of the probe cable, I will have to call LHR tomorrow.
I will give it a good thorough look tomorrow, thanks again for the advice.
Thanks Bud for the assistance, the only thing I changed out were the sandpaper belts for the rubber belts and cleaned out the sawdust from the bottom of the mechine.
I have only used the scanning probe a few time with no problems, now all I get is Z axis 248. Any assistance you can render to resolve this matter would be greatly appreciated, thanks in advance for...
Thanks Ken810.
Hey Ken810
Is that dragon you used still available on the forum.
Great job, what type wood did you use, and I love the add-on at the bottom of the slab.
Very nice work Brad, post pictures of your finished product. Thanks for sharing.
If that works then I'm all for it, where do I get the old upload, everything I have has 1.120 on it.