Thank you for your response!
Sadly I do not know anyone around me that has a CarveWright. I did find a generic key pad used in Arduino projects. It looks like the same type re-branded by LHR and...
Type: Posts; User: joshmlawson; Keyword(s):
Thank you for your response!
Sadly I do not know anyone around me that has a CarveWright. I did find a generic key pad used in Arduino projects. It looks like the same type re-branded by LHR and...
I've checked all the connections and they seemed solid. I've gone through the computer with one of my magnifying glasses I use for circuits and didn't see anything obvious. It started when I updated...
I have a series A machine and has anyone had their keypad malfunction? It works, sort of. It's like some of the numbers do not correspond to what they are supposed to and some do not work all...
I'm having the same problem and gone through all the checks. I've come to the conclusion that it must be the ribbon from the control pad because buttons stop working sporadically. As far as power...
Thank you for all the help!
I apologize if this question is too obtuse but what is the difference in the patterns that have 16-bit on them and the ones that do not. Do I need a special bit to handle the patterns? Thank you in...
Great news, I was able to download a previous version (1.77), did a complete uninstall and installed the 1.77 version. The machine is operating back to normal again! Thank you everyone for all your...
Thank you for the response. :) Should I repost this with "BUG" in the title, so the software developers can track it? Do you know where I can download version 1.177? I went from 1.6 all the way to...
I have a CompuCarve Rev A and just updated my firmware and software to 1.178
I built a new project and uploaded it to my card. I can load it in the machine but when I get the option to "Cut Board...
I'll have to check that too. I taped a board and went to run the project again but started getting power fluctuation errors constantly. After reading all the posts about it, it looks like I'll have...
I also tried pine and red oak (no flooring). Each one is off by just a little bit on the cut out. I'll have to give the masking tape a shot. It's almost like I need to recalibrate the machine or...
I downloaded the Plaque/Business card holder and the first prototype turned out great. I used a discarded 3/4 piece of pecan flooring. When I went to do another the machine is off by around 1/4 or so...
I have the same problem. It happened yesterday. First my board sensor went out and I had to replace it and now this little switch. Needless to say I'm a little frustrated but I look at this as...