Unfortunately, tabs for cut paths are not shown in Designer. (I think that where the tabs end up depends on where the cuts start and this is determined as the project is "compiled" onto the card.)
Type: Posts; User: bergerud; Keyword(s):
Unfortunately, tabs for cut paths are not shown in Designer. (I think that where the tabs end up depends on where the cuts start and this is determined as the project is "compiled" onto the card.)
Check out the brass roller. Something may have interfered with its tracking. When you press it down (like the board would), does the O ring touch the rubber belt??
How about low head pressure? The...
Did you see what happened? Did the piece break out and jam? If so, higher tabs may be in order. MDF is not very strong.