I have used my carvewright machine for several years doing the basics.
I am trying to go to the next level.
I would like to use a monogram letter and put a name over it.
What is the best method of...
Type: Posts; User: Woodlegend; Keyword(s):
I have used my carvewright machine for several years doing the basics.
I am trying to go to the next level.
I would like to use a monogram letter and put a name over it.
What is the best method of...
I have sent my machine to get it upgraded. I confused with which bits will work. I looked at my bit set and the 1/2" has a nut, that i assume I remove to use the 1/2" straight bit. The 1/4"...
Thanks for everyones help. I found a slight tear in the keypad cable that probably is the cause of the frozen keypad. Will replace
My machine needs to be fixed and I could use another machine. I would offer $800, that seems to be what used machines are selling for.
I was told problem was with Memory card. I replaced memory card and when I begin project I am only able to get to the stay under roller prompt 1 or 2. When I hit the keypad for either 1 or 2...
I finnally was able to solve the close cover switch, but now I only get to the message for option 1 stay under rollers. When i hit the keypay it will not do anything. Checked the keypad connector...
Checked plug and white wire was to center of machine. Any other suggestions appreciated, Thanks.
I checked sensor option 7 which said cover open.
Is there any other suggestions?
Thanks
I had a error message 319. I checked the brass roller O-ring and it was fine. I cleaned and blew cout the two roller switches.
I changed the board to see if that solved the problem. And i kept...
How do you find out how many hours machine has been used?
Need help with eliminating carving backround when importing a picture.
I import a picture of say a logo and invert the carving area. But the backround around the picture is also carved slightly....
I have purchased a pattern and installed it in my carvewright favorites, but it won't allow me to use it. I have tried to license it but it does not appear in the license box. I tried to update and...
How do I get pattern editor installed?
I have purchased the complete package with scanning probe, but pattern editor does not show up in the licenses.
I have installed the z-motor and now I cant' get past the close cover message, even if cover is closed. Do you have a solution?
Thanks I was able to get the plate to touch and then I got a 246 axis error.
What is the cause of this error?
Is it the plate on the opposite side of the of the sensor? Where to you stick the tape on the plate side that touches the bit?
I have not been able to get past the load bit command. I load the bit and the machine goes to homing and goes back to laod bit. I have reloaded the project and rebooted and have the same problem....