I wish I could have made the conference, and thanks lynnfrwd for the invite for Friday night. I was a real pleasure to be around so much talent and to meet the Legends Of Carvewright. And of course...
Type: Posts; User: trplbogie; Keyword(s):
I wish I could have made the conference, and thanks lynnfrwd for the invite for Friday night. I was a real pleasure to be around so much talent and to meet the Legends Of Carvewright. And of course...
Anyone have Hole in One design to share or sell???
Thanks Bud, I am using the rock, but some simple 3 in 1 oil took care of it for now
I keep getting Z-Axis 313 error message and cannot figure out. Comes up after putting in 1/16 carving bit and starts the homing process
Thanks in advance
Very pleased that the new bits with pressed on shank and the small rubber spacers all work very well with the rock chuck also....along with Floyd Harris's dc.....carving is even better. When ny rock...
Thanks, the one piece cut, I did not stain but put an acrylic spray on it. I am trying to go to brush on poly, to save on costs. Out of ignorance, what is BLO?
Thanks again
The plaques will be 17x11 1/4, there will be over 20 total. They will be for inside display, team awards for all female redfish rodeo tournament. I want to have the nicest finish possible as I have...
just the goss and no stain????
What is the best finish for Mahagony, I have considered Minwax natural and also teak oil.
Any suggestions??
What is the problem with the roller? and where is the machine, and hours
thanks...look for more ideas
I do use the pre stain conditioner especially on pine. trying to double up on the ends on single coat the rest.
Thanks
Probably on the forum somewhere, just can't find it. How do you keep the cut ends of the boards from staining darker then the other edges.
Thanks
Any news on the new chuck??? After complete maintainance on mine, it is having just a few small problems, but find myself having to get new bits. Funny how all my bits fit well except the 1/8 and...
I should have asked my wife.....she just handed me Glad Press'n Seal plastic wrap. Lightly tacky on one side and not expensive at all. Will try that, and after I screw up my machine I will take it to...
Makes me wonder if blue painters tape would work.
I could use tips about sanding. I typically paint a lot of lettering. I cut, then put heavy coat of gloss....spray paint then sand...pain in the .....
Any suggestions to make this easier. Also...
So. you stain also before shellac and carving? Then the paint just wiippes off. Or did you not stain the wood as I cannot tell from the photo
Thanks again
It has Univ of Bama Logo, but it is Alumni logo and I have alumni permission to use If this is the one with the cutouts it is the correct one
yeah it says it's sorry. Contact LHR for support or fix. At least it apologized:)
Has anyone ever gotten the error 24 when project was compiling to the card?
I tried 2 uploads of basically the same pattern but one would load the other gets the error message. And of course it is...
Got a new QC and two new bits. They gave me a pretty good idea of what their new device will be and it sounds very good. As with anything time will tell. I get to go to LHR some and they are always...
Sitting here at LHR waiting for my QC to be replaced. Still cannot believe it is not warranty. However everyone here is very nice. New one is supposed t be out in Jan. Sounds like it will be the way...
I may have to convert to rock chuck. I have had my machine 3 weeks, and nothing but problems with the QC. I believe I am very good with my cleaning. I clean it out with each bit change even during a...