Im interested if still available
Type: Posts; User: bogwojny; Keyword(s):
Im interested if still available
im interested if still for sale.
Hows it going?
This still available?
How many hors are on machine and what you looking to get out of it?
Thanks for the replies. I realized that after 4 hrs of trials and errors the Center Text actually worked good in demo mode especially after figured out how toiuse the bit depth and choosing the right...
Might not be in right area but at work we have 1/16 plastic placards we use which we have to get engraved from another company but since have a CW Im going to attempt to use this and save us some...
Its not carving evenly in some places....
Its in the middle of the shield this one isnt to bad but sometimes its alot worse...59917.0
Not sure where to find if its here but when carving the pattern ends up having areas that either carved to deep or not enough through out the carve anyone have any ideas? Maybe compression issue?
The error comes up when i press the project and throws the error before it even moves...was testing the y axes by hand and its working but the z when move it up and down its not showing...
Got everything in today replaace it all and still the same result....z axis stall...error E06-1313...shows this error after selecting the carving i want to do.....any suggestions????
Just had the cut motor rebuilt so no worries there. Already have spares for the Y and X gears as well and a cpl bearing rollers.....
Ordered new clear cover and both switches and FCC cable and cpl bits...
get this error message after I press the pattern i want to carve so instead of starting to measure or anything I get this error..any ideas?
Awesome now Im getting the Z axis stall E06 0313
well wired the left side 2 wires together since the plastic knob is broke that engages it when closed. Still get the please close door notice. When push the button on the rht side the bit moves for a...
I just noticed the left side tab is broken off.....
Having an ongoing problem with the keypad saying to close the door...is there a way to bypass this?
STill available?
Recently moved from Virginia back out to San Diego, Ca...anyone near who also works with the CW?
That worked thanks!
So what do I have to do to correct this?
Checked it and one side with the paper came out. What do I have to do to correct this?
Ok Ill look into it now....
While the machine is running its carving the pattern as it goes across the width its going fine until it goes over the opposite end and carves not as deep...anyone knows what that could possible be?...
Just found a slight rip in the cable. haha