Search:

Are your drawings made with sketchup?

The last time I tried to vacuum the sawdust out during a carve, I got a static charge that killed the project. Fortunately I was able to power cycle and start over, (BTW, this was many years ago.) ...

I would be careful and not vacuum during a carve. A vacuum causes static electricity and can cause some strange things to to happen to your machine. The worst of which could be damage to the...

Thanks Jerry, much appreciated.

Jerry, I would appreciate pics.

I have used keyhole bit by creating a line horizontal to the top, (about 1-1/4" long) setting an appropriate depth and selecting the 1/8" cutting bit. Now when it is time to cut this line, insert the...

I don't recall the user but maybe they will see this and show some pictures. They glued two different woods together and did their carving down to the next layer in some areas. The results were quite...

Excellent! A project well worth bragging about. I like it! Would you be kind enough to tell us where you obtained the hardware?

I plan on building a tool chest to use for my gun cleaning...

I did drill some 1/8" holes and the other holes - with the 3/16" bit. What a dummy! LOL Sometimes it just takes someone else's eyes to see what's really going on. I had forgotten I had the 3/16" bit....

I am using the 1/8" cutting bit. It is in the carvetight chuck. What would be the best way to check for run out?

I had an occasion to drill numerous holes. I needed three different sizes of holes. The holes drilled are uniform in size but are larger than designed. They are round so I believe the X and Y axis...

I finish the entire surface using shellac including the carved portions. Sometimes a couple of coats. This seals the pores in the wood. I then use either a paint pen or a brush to ad the colors I...

Download the appropriate version of software from the link above. Load it up and it will ask you to register it. When you do load, it if you are using windows you must run the program as...

Search is your friend. Just search for Punisher.

Oops! Sorry wrong post...

http://support.carvewright.com/learning_guide

I tried to download the entire guide but when clicking on the link it said forbidden.

Yep! Been there, done that. Fortunately for me my better half reviews and catches most of my mistakes. Do all of the above and ask someone else to look at it. I'm sure everyone here would help if you...

I am not totally sure on windows 10 but this has worked on all other vers of windows
Press Windows+R to display Run
type in devmgmt.msc and tap OK
Scroll to the bottom and expand Universal Serial...

Although they said it wouldn't be available to ship until after the 2nd, it arrived yesterday. Now, if you are like me, I usually lose the instructions that come with my devices. To help overcome...

I ordered one but they are now back-ordered. :( On the brighter side I went here:

https://thecontainerstore.knoji.com/promo-codes/-ds-15-off-your-purchase-at-the-container-store-singleusejww/
...

I do not know where the muffler is for my A machine. Sometime ago someone suggested connecting a shop vac in its' place. I turn the vac on for a few seconds after finishing my carving. Definitely...

There is a group of campers in the Pattern Depot.

Henry, what do you think about removing some of the 'filigree' type patterns and in it and turn it solid? This way it wouldn't be so busy.

Henry, I'll give it a try. Thank you for the help.

Bergerud, I have found higher res graphics but they were jpg.

I am trying to make a plaque for a young man who will go in as Master Councilor of his Demolay Chapter in a few weeks. I have spent numerous hours trying to turn this picture into something I can...