Search:

Hi folks,
Its been a while since I've used my machine, can someone remind me how to use the bit selection.
Thanks Davidbf

Thanks to everyone for the help with my Z motor stall and carving thru board. I found the problem it was the computer tape wires that goes to the Z motor.
Thanks again for the help and Happy...

when I try to start a carving or test the Z I getE06-0313. first it said clean board sensor after cleaning the sensor tried to start carving and got the error and also get the same error when I try...

Does anyone know what err E06 0313 is? need help

Hey Al,
My machine is a B so I would say its the 18 pin ( not sure } I will pull it apart and clean the Z motor and everything around it, the cable is good no bends or folds that should not be...

the belt, cable and pully gear look fine. Can u tell me how to clean the encoder disc

my machine is cutting thru the board when I start a project it does not matter what the depth is set at it starts to carve then goes rite thru board.
Thanks davidbf

If you still have machine what are you asking now

Do you still have machine

Have you sold your machine yet ?

Have you sold the machine yet ???

do you still have machine, how much ?

what are you asking for your machine

I'm looking for a board sensor and possibly a Z motor anyone have an extra

Has it been sold

When I try to upload a project on the card I get { FLASH OPERATION FAILED ERROR CODE 1167} What does this mean

Thanks Al,
I guess I should have given more details. The carvings starts out ok but after a couple of minutes it starts carving a straight line from side to side and will go thru the board. I just...

Does anyone have any idea why my machine is carving to deep? I have checked the depth I set on the pattern, .125 but it will carve thru a 3/4 inch board from side to side.
Any help or idea will be...

If anyone is looking for large amounts of kiln dried hardwood my Mother-in-law is selling out her sawmill due to loosing her husband. There is over 40,000 board feet of native Il. & In hardwood.
She...

Call me mike, if you want to. You know who this is......................................................................................... It's me dummy

Thanks to everyone for the good words about my carving.
HAPPY HOILDAYS TO ALL. I'm sorry if I didn't answer all your questions but some of the stuff I just don't know.

I'm not sure what all the stuff is you mention. I just design something I like and see if the machine will carve it. I do the photos in paint.net & photosacpe and import them. I don't have centerline...

The total thickness if the material is 1 inch. The Maple is .23 and the Walnut is .75. I allow about.02 for glue thickness between the maple and walnut. I set the carving depth at .25. The light...

Does anyone know what the Z & Y axis #'s should be or is there a set # they should be at ??? When I check My Z axis I get A=54.87 / M=129.69.
My Y axis A=54.63 / m=256.00
also my length measurement...

HOW DO I JOIN THE CARVING CONTEST
davidbf