have to many errors with carvewright will be buying shark plus soon to try
Type: Posts; User: baby15; Keyword(s):
have to many errors with carvewright will be buying shark plus soon to try
when you change the controller do you have to recalibrate the rubber belts PM me
thanks will check them out a lot cheaper than rockler
will try that
okay put stop collar on first then the collet i was thinking it went on top of collet had no instructions on it thanks
boy would like to know about this o carve reagion how do you do that
1 had a few projects stop on me an had to start project over with same board an it found the same spot
i have a feeling it could be the memory card. had the problem the outher day an i have three cards but did not pay attension to which card have them numbered if it happens again will know
changed cards with same project running okay for now
ya tryed new ribbon 2 stiil same
do the stop collars go on top of collet want to use the 60 degree bit have the collar but 60 degree looks short or do they have a longer one for carvetight had it for 3 days now
how to use the stop collar on the carvetight are they used on top of collet
well i swithed power supply with the one in my working machine still 313 error everything else is new except controler
any one know where to buy a 60 degree an 90 degree bit with 1/2 shank for carvetight
i ordered 2 springs to try
is this the same spring in the carvewright
i clean my rollers with fine steel wool i just rub lightly an blow clean with air after every project
Exception stack fault anyone know what that means
i have had fatol error 4 an fatal error 3 where is the pdf files for it
machine was going thru load bit cycle quite a few times an found the bottom roller was not tight on new carvetight. back carving again no errors.
changed motor on y trunk. i am back running but it gave slipped y belt error. put new carvetight on an checked the belt not slipping an the y belt adjustment belt is adjusted all the way?
ya it was on z trunk never new about that one got 313 error on outher machine an i think its the controler. will mess with the outher one tomorow i think y motor is loose will change it...
okay got that fixed now it says clear board sensor change that reading 150 an it still says clear board sensor
will try that
put the controller back in my outher machine now it wants to jog to scan what happened aint one problem its another