Search:

Type: Posts; User: Zap; Keyword(s):

Search: Search took 0.00 seconds.

  1. This is MDF so I expect minimal amount a wood...

    This is MDF so I expect minimal amount a wood movement. But yep, I use blue tape every time. My regions are off in both X and Y so I don't think this is the roller skipping. I'm thinking the...
  2. ah yes, it's a cutting bit. just typed the wrong...

    ah yes, it's a cutting bit. just typed the wrong word. :)
  3. Shape is one size in Designer and another when cut.

    I am making some holders for some tools and want to cut recesses in MDF the shape of the tool. I'm using the 1/8 straight carving bit and when I make a rectangle in designer that is 2.5x0.75 it comes...
  4. Thread: Start U in TX

    by Zap
    Replies
    1
    Views
    41,219

    Well, this is quite the old thread but I am in...

    Well, this is quite the old thread but I am in Kaufman county.
  5. Thread: Z Axis Stall 308

    by Zap
    Replies
    32
    Views
    12,587

    I just had time to go check this today and...

    I just had time to go check this today and although I didn't see any sawdust there I blew it out, along with the rest of the Z Truck, really well and I'll be if it didn't start carving!

    Thanks...
  6. Thread: Z Axis Stall 308

    by Zap
    Replies
    32
    Views
    12,587

    Thank you. I plan on calling LHR on Tuesday and...

    Thank you. I plan on calling LHR on Tuesday and then order whatever parts needed. The sandpaper belts aren't tracking correctly and have worn a little on the control pad side so I figure I'll replace...
  7. Thread: Z Axis Stall 308

    by Zap
    Replies
    32
    Views
    12,587

    Yes sir, after the bit selection prompt it moves...

    Yes sir, after the bit selection prompt it moves the truck out for you to insert the bit. Then when I hit OK it spins briefly.
  8. Thread: Z Axis Stall 308

    by Zap
    Replies
    32
    Views
    12,587

    Well, I got the one carve done but now I can't...

    Well, I got the one carve done but now I can't get it to carve again. I goes through everything just fine. Rollers back adn forth, Y axis back adn forth and Z axis up and down during measuring and...
  9. Thread: Z Axis Stall 308

    by Zap
    Replies
    32
    Views
    12,587

    Gotten further: I leveled the head asembly...

    Gotten further:

    I leveled the head asembly and while I am still getting an occasional stall I have gottten two small carves out of it.
  10. Thread: Z Axis Stall 308

    by Zap
    Replies
    32
    Views
    12,587

    Hello all! I am the lucky recipient of Badger's...

    Hello all! I am the lucky recipient of Badger's machine. I have gotten it home and after an epic battle removing the QC (I think Badger had dipped it in loctite :D ) I got the RC installed and tried...
Results 1 to 10 of 11