you can use fiberglass to repair the corner post you can git a repair kit from a boat shop
Type: Posts; User: hray; Keyword(s):
you can use fiberglass to repair the corner post you can git a repair kit from a boat shop
i sovled the sharpedge problem on mt truck by sanding a slight raidus on each side
of the channel in the truck
place a jumper wire across left hand swicth go to the key pad sencer check if it reads closed remove the jumper dose it read open then it is a bad swicth
i would be glad to share the file
that was the pattern that i posted some time in the past i am glad some got use it
i make bible boxs and give them to the famlys of veterans that have passed away
i use dye to stain all my poplar60861
Thank you and your son for your service i was a combat medic in veitnam 67-68-69 was shot at a lot and hit twice the last time was shapnel from a 82 millimeter mortar
thats the on that ended my...
clean around the crack with alcohal carefully v the crack and j b weld the crack and put 1/4 with skin over the
carcked portion of the motor i have one trhats over 5 years old and its still going
ray321 i have new qc never instaled you can have it for postage
you may send me a pvt msg if you want it hray
yes the ct upgrade is a good investment you get smoother carveing and less vibations which is better for your mch
i too had that problem it turnd out to be a bad bearing on the y truck
i have a new qc its yours for postage
jossef i have new qc never used you can have it if so send me a privet msg
go to klockit.com they have a prod called kraftcoat could be just what your looking for
i to had a loose encoder disk i mixed up a small amount of five min epoxy and placed a small amount as in one drop of epoxy on the shaft where it meets the disk
the disk is a friction fit that...
old vet combat medic
ada ok 74820
at my age being called jr seems to put spring in my step
i had the same probiem with my carver check the encorder disk in the z motor mine was loose fixed it with
a spot of five minite epoxy on the shaft and disk
you can go to the key pad press 0 then 7 scoll to the rollers lower the head untill the rollers just compress the head pressure should be just about right
the same thing hapened to me on my a model machine i just removed the handel and sprayed wd40 in the handel hole it ether cleaned out carveing dust and posiblt lubed it has been working fine now
for...
new2carving here is a couple mpc,s for my bible boxs people like these real well
new2carving i use just rectangle box with 45ed corners an inset bottum and hinged top
i will be makinb some this weekend and i will take pics here are two tops
new2carving i use just rectangle box with 45ed corners an inset bottum and hinged top
i will be makinb some this weekend and i will take pics here are tow tops
i do well with bible boxs the real key is the custom tops
when i recived a new motor it did not want to start it may have recived
some ruff handeling checked the brusses and reseated them then iran just fine if that is the case it is an eazy fix