Search:

I would try the paper version of "Transfer tape" or "Transfer paper". You shouldn't have any problems with it. It is mostly used to transfer vinyl Lettering and decals from its backing to its new...

If all else fails take averyones advice, put it in a blender, sort it out, then click here. LOL. http://www.carvewright.com/forum/showthread.php?t=2238&highlight=CHAIN+LINK

Don't know what to say, I woke up this morning, read the new posts, and went to verify if I was right last night. When I opened the same project it was back to normal. I checked a lot of projects and...

Don't remember where they where, but i saved something back when. Try these and see if they help.

No. No confusion here. I am talking about the pattern editor, and being able to change the pattern or patterns I download and or buy into patterns I am going to use on a regular basis. Now I can't do...

I put the cursor all over the project, and you were right. It confirmed what I saw, the project was inverted. The problem is that it is lying. It may say and look inverted but it carves correctly. So...

The way I see it, a pattern is just that, nothing more. If I buy a pattern it is just a guideline, I want to twist it, tweak it, push it, pull it, and do whatever it takes to get it "perfect" the way...

Sorry about the pic. It was too big to get uploaded, and i didn't notice it the first time around.

My level of pisstivity just went way through the roof. I opened designer, then one of my .mpc's, and everything was inverted. I thought I may oopsed, so I re inverted all of it. That was the biggest...

The way I see it if I buy a pattern, it is mine, if I edit it oh well. I own it I should be able to make it look like I want it to. I think somebody somewhere is just getting a little too greedy. But...

There are more look at the top left hand corner, above the patterns there are page numbers. They are ok, but i am not sure about the prices. $10-$75 so far. I ran out of time to look, got to go to...

Hope no one is having the same problem as me. "new update, download, install, register again?, NOT," so now i get to uninstall for now and reinstall the old one. Hopefully. Something about the...

My problem was that the board had a u shaped cut out at one end. The sensor would do its job and see the end of the board, and the compression roller switch would also do its job and report that it...

The only thing i can tell you is that the sensor sees the end of the board, but the switch on the compression roller is telling the board sensor that the board is still there. So now you have a...

Thanks. I guess thats what happens when I look at these pics with my eyes wide shut.

Just wondering, what the little red button on the black box behind the lid "cover", is for?

Thats exactly what it looks like. Just call the people at carvewright and they will walk you through what you need to do to fix it.

Thanks for all the help. It just happened to be a loose ribbon cable on the Z axis motor. Thanks to the excelent support it is up and running great.

Thanks for the help and the quick response, I will be counting down the time till I can cranker back up. Thanks again

I called and was told someone would call me back shortly, that was over an hour ago. Im not complaining yet. I just keep getting a busy signal when I call back, I understand it is a very busy place....

Thanks, but none of the boards are deformed at all. Each of the pix are from different boards. It is iether a mechanical or software problem from what i can tell.

No matter what i have tried this project goes in all the wrong directions. It starts off good, then gets a mind of its own. I have uploaded a screen shot of the pattern, and plenty of attempts at...

Im am still looking for the scanner it does not seem to be for sale anywhere. anyhelp would be greatly appreciated. thanks

If you see the tag with the model number on it, then look at the number under the barcode. That is where the serial number should be.