Search:

Type: Posts; User: geenweb; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    825

    Hi, Machine is still for sale. I rarely log...

    Hi,

    Machine is still for sale. I rarely log into this site, so please email me.

    judgejrt, sorry I never saw your private message until now.

    Best,

    Gene
  2. Replies
    2
    Views
    825

    CompuCarve for Sale

    Hi, I'm selling my CompuCarve (CarveWright A version machine) that I purchased in 2008. It has very low time on it, and is in perfect working condition. Cut motor time in only 5hrs 14min, and...
  3. I submitted two posts on Friday, but for some...

    I submitted two posts on Friday, but for some reason they were never posted. I attached photos. Perhaps I exceeded a size limit or something.

    Thanks for all of your responses.

    I removed the...
  4. I pulled the black cover off the back of the...

    I pulled the black cover off the back of the Z-motor assembly and found the Z encoder disk. It looks fine and spins freely in the sensor as the Z truck is moved up and down.


    Gene
    81549
  5. Thanks to all for the suggestions. I do have...

    Thanks to all for the suggestions. I do have revision 1 of the board with the older 18 pin connector. The FFC cable looks perfect. The "glue" where the cable goes into the FFC cable guard on the Z...
  6. Z Test & Cut Motor Test give Z Axis Stall Err E06-0313

    Hi,

    My machine stopped about 30 minutes into an hour raster carving of lettering on a project I've been working on. It had a message to clean the Z-axis rollers and press enter. I always clean...
Results 1 to 6 of 6