In my very first post, I was planning to use 3/4" Oak. Then I mentioned finding a 1" thick piece of HDPE that would be better. Then in my most recent post I mentioned doing test carves in 1/2" MDF...
Type: Posts; User: Cgav34; Keyword(s):
In my very first post, I was planning to use 3/4"...
In my very first post, I was planning to use 3/4" Oak. Then I mentioned finding a 1" thick piece of HDPE that would be better. Then in my most recent post I mentioned doing test carves in 1/2" MDF...
The MDF was 1/2". The HDPE is 1", plus a 1/2"...
The MDF was 1/2". The HDPE is 1", plus a 1/2" sheet of MDF under it as the sled. Set the total project height to 1.5" in the software when attempting the final carve in the HDPE.
It almost looks...
Well, I was going to go the route of the...
Well, I was going to go the route of the 1"x12"x18" HDPE. Found some stone textured spray paint and was going to paint the letters and graphics black...kind of a faux stone marker.
Did a couple...
Never thought about Corian. Looked and called...
Never thought about Corian. Looked and called around the shops in the area, but they all deal only with stone.
What about HDPE? Found a no frills cutting board on Amazon, 12"x18"x1". Kinda...
Grave Marker
I'm carving a grave marker for a close friend of mine who recently lost her fiance.
I'm carving it out of oak, and plan to put SEVERAL coats of spar urethane on it. Any other special...