I wanted to let you guys know the new flexshaft was the problem. LHR replaced the flexshaft and the replacement fit correctly. Hard to believe a machined part having a size difference enough to...
Type: Posts; User: Robert V; Keyword(s):
I wanted to let you guys know the new flexshaft was the problem. LHR replaced the flexshaft and the replacement fit correctly. Hard to believe a machined part having a size difference enough to...
I do not see a burr of any kind. It just seems to get a little larger in diameter. The edge seems to slide on about a 1/16 of an inch and goes not further. I will call LHR tomorrow and see what...
I have now tried pulling the clamp that applies pressure to the bearing/ball. Even with the ball completely out of the way the new flexshaft end will not completely go into the top hat. I removed...
Clint,
I verified the shaft is seating correctly into the Z truck. I have actually removed the top hat and with it removed cannot snap the new flexshaft into the top hat. So I know its not the...
okay both the old and new measure the same. After closer inspection of the fitting on the new sheath I noticed the groove is significantly less rounded on the new flexshaft. The old one has more...
I will measure and see if its actually different. My old sheath shows wear on the inside cut motor end. Afraid to use it again.
I was installing my new Flex shaft assembly and ran into a problem. I cannot seat the new flexshaft into the top hat of the Z truck. Yes the spindle is seated correctly and I verified hand turning...
I have over 300 hours on my machine and was noticing the flexshaft getting very hot. I ordered a replacement Flexshaft and I cannot get it seat into the top hat of the z truck. I removed the top...
thank you.
The lizard was my first use of the scanning probe. I used a plastic refrigerator magnet to scan and basically enlarged it so the feet were able to carve.
I have been tinkering with my machine for several years and never posted any projects. I finally transferred a few photos from my phone of some recent projects and thought I would share with you...
Great Thank you for all the help.
Robert
I can do the same thing here with corel. Thank you for the offer.
R
Sorry for the confusion. I'm trying to carve the word "Indianapolis" like this photo. 77673. I usually monkey around with software until I figure out a work around to get something near what I'm...
I looking for advice on how to carve the word "Indianapolis" in cursive without any background.77670Similar to the photo. My son is wanting this to match some of the other Indiana themed items in...
Thanks Al, I will take a closer inspection over the weekend. I ran three projects today with no errors. I have had off and on issues since I bought the machine 4 years ago. Hard to believe the...
I finished a project last night and today I tried to load a new project and I kept getting the "Clear Board Sensor" error. I cleaned the machine completely and still had the same problem. I then...
Forgot about the card trick. I use that trick for my scanning probe all the time. Thanks for the reminder.
Robert
Sorry I started the thread from iPad. Will switch to the pc so I can attach mpc.
Robert
Been using the CW for a while and now working on a address sign for my family members. My issue is when I add the plaque pattern to my board the pattern is being carved .008" where I will be using...