I did it. Put the Hide on the very long project, uploaded again. Went through the bit setup on the machine, after set up, I put the short 60 bit in place of the 1 16 and let the project Air Carve for...
Type: Posts; User: edsingletary; Keyword(s):
I did it. Put the Hide on the very long project,...
I did it. Put the Hide on the very long project, uploaded again. Went through the bit setup on the machine, after set up, I put the short 60 bit in place of the 1 16 and let the project Air Carve for...
It was about to carve through the pattern, so I...
It was about to carve through the pattern, so I raised the cover a put in place a shorter bit that does not reach the wood. So I will let run through the sequence and put on the 90 bit in 6 hours.
...
I'm trying it now, thanks so much
Sent from my...
I'm trying it now, thanks so much
Sent from my SM-G930P using Tapatalk
Do you think I can go to the original computer...
Do you think I can go to the original computer layout, hide the carvings, and save it, then run again. Would it want to carve the depth and remove the carving that is there. I just don't know, I...
Almost Done Dog Gone
A friend asked for 3 identical plaques. So I figured save wood and time since all 3 were the same, I put them all on a single board 10 inch x 62. At compiling it said 8 hours for the carve. No big...