Really nice work gekepko! Thanks for sharing.
Type: Posts; User: ridgecrest; Keyword(s):
Really nice work gekepko! Thanks for sharing.
I recently created a Mancala board 22" x 5" x .75" with the pockets being .375 deep. I was quite surprised when I uploaded it in Designer 3.102 and saw that it was going to take 1 hour 34 minutes...
Zan29 or aokweld101
Would you mind sharing how you took the picture and turned it into the great MPC? What tools did you use?
Thanks
When I right click on a pattern, I see 5 options: Delete, Rename, Export, Open in Pattern Editor, Open in Pattern Sculptor.
Reid
Yesterday, I installed the 3.1 release of Designer and today I received my pattern editor license which I immediately installed. When I double clicked on one of my patterns I got "Error: Pattern...
Nicely done Kelsky. What wood species is that?
I will check the wire tomorrow and report back. I did replace the sensor this past October.
Reid
This afternoon, I performed a sensor check. I used a white sheet of printer paper for the test. I noticed that in the middle of the machine the reading was acceptable but as I moved the head...
FWHarris, it did not give any other message. However, I vacuumed again, re-taped the sled and tried again. Now I get "undefined error E54-0269".
Al, I used this same sled earlier in the day and...
I need to complete a carve today and my machine keeps raising "Undefined Error Err E396-0269" when measuring my piece. I am using a sled which is 21"x14". I have used this 3/4" MDF sled many times...
Nice clean design.
Nicely done Tom and happy belated birthday. Thanks for sharing.
That's a very creative fix. Nice job.
Lawrence,
Congratulations on your retirement! Wishing you the best.
Geomooq1,
Am I right in assuming that the color value for .23 and .24 should be 8 and 4, not 80 and 40?
Thanks Eddie and Geo,this chart will be very helpful to me.
fwharris and lynnfrwd, I have not checked the head pressure but I will do so tomorrow and post my findings. The first carve was on a new sled that I made today. The board to be carved is 16x6 and...
I've been trying to make a couple cribbage boards and I have been unsuccessful as the holes are not properly positioned. I have a purchased pattern that I tried carving as well as a cribbage board...
Yes, My machine shipped with factory installed rubber belts.
Al,
Thanks for your speedy reply. To make sure that we are talking about the same piece, I have attached a drawing of the washer. This washer is on the key pad side of the rear compression...
I have been unable to carve any of my last three designs. I have a C machine with probably less than 50 hours on it. All my boards are milled S4S by me on my jointer, surface planer and table saw. ...
Very impressive video! It will surely bring a lot of attention to your awesome work.
Thanks for sharing.
Greg,
I recently had the same experience. I am going to try their detail abrasive brushes next. Here is the link:...
That is an awesome piece of work Sharon and you are an amazing painter. I'm sure your great grandson and his parents will love it.
Thanks for sharing how you painted it Chief.
They are amazing. . . .Great job Chief!
I am still learning the basics of carving and my finishes have just been simple stains and clear gloss. If I had to finish your carving, I wouldn't know...