Search:

Type: Posts; User: Wood Art 1; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    19
    Views
    27,059

    yup. real trick getting the rotary to carve on...

    yup. real trick getting the rotary to carve on my blank. Usually carve a little of the fixture on an oversize blank. If I could carve the two sides first, I would need a jog to center on the...
  2. Replies
    19
    Views
    27,059

    Response to bergerud. yup, did the alignment. ...

    Response to bergerud. yup, did the alignment. This was the best tread alignment so far. Have attached pic of two fixtures I use. They're not fancy - fixtures just need to work, sometimes they get...
  3. Replies
    19
    Views
    27,059

    Thanks to everyone for the encouragement. ...

    Thanks to everyone for the encouragement. Response to zan29. 1) Carved tread on rotary. 2) carved outside (has bolt detail and 4 perimeter slots) no pierce. 3) carved inside deep enough to...
  4. Replies
    19
    Views
    27,059

    Floyd, and a great thanks to you sir, for your...

    Floyd, and a great thanks to you sir, for your patience in helping me solve the mechanical issues. Still having a problem getting the carves to center properly.
    Jerry
  5. Replies
    19
    Views
    27,059

    Am working on a tractor to go with. Hopefully by...

    Am working on a tractor to go with. Hopefully by summer. Been watching bergeruds latest fixture for two sided carving - great idea/project - will tackle later this year.
  6. Replies
    19
    Views
    27,059

    Tractor Tire

    Been working on this project for a while, finally got a piece that resembles a tractor tire. My first rotary project. This just came off the CW, no clean up, no finish yet. Three carves to get...
Results 1 to 6 of 6