Search:

We have two CarveWright Version C Machines with heavy duty traction belts. We are asking $850 for each machine or $1000 for...

We have two CarveWright Version C Machines with heavy duty traction belts. We are asking $850 for each machine or $1000 for each72080 machine and the rolling cabinet they are attached too. If...

the y belt seems too tight the head will not move with ease across the rail. i have cleaned and lubed it and loosened the adjuster and tightened it and it still hangs up. please help.

I have the C version machine and it has about 200 hours on it. I haven't carved out anything for about a month and it was working fine when i put it away. Got it out today and blew the dust off went...

they sent me new nuts and i put them on and i think all i have to do is adjust it. it goes up and down fine till i put the cover on that side and it hangs up

i swapped them out and it works fine thank you for all the help

i might just swap it out with my other machine that has issues with the head. thank you

we are from atchison kansas just north of kansas city

no i don not

ok thank you i will give the techs a call in the morning and have them send me new ones

i removed the 2 screws and the plate and there was some dust in there i blew it out and reinstalled the spring and bolted it back in place and it still will not say compressed

it sure acts like the nut is stripped because the shaft is moving fine and i can pick up on the head and it will move. thank you

i have a c version machine and with about 150 hours and the right side does not keep up with left and gets hung up i have adjusted the rods and still hangs up. i tried to use it it made 1 good pass...

i have a c version machine and the front compression roller says released all the time. when i push it up to compress it i can here it click but it still says released i have blown it out with air...

Thank you very much for everyone's help, I appreciate it...:D

I am curious if you can change anything in POM's? I am carving out The Decorative_Ornamental_Box and I'm trying to learn how to curve the ends. They curve so nicely with the POM but when I try to...

My husband is asking if you can strip the bolt on the opposite side of the crank?

I guess I'm not on the forum enough b/c I'm looking for your number and email but again no luck :-) Please bare with me I'm learning the forum

Thank you for your help but it's stuck half way down and we've tried the allen wrench multiple times and it just wont move on the opposite side of the crank. The side with the crank moves freely. ...

After hours of cleaning and lubricating the machine I can only get the machine to slightly move on the side with the handle/crank and the other side will not move. Any help?

Hi there, my husband and I just got intro woodworking together as a hobby. I design and he finishes. We are in the process of building a toy box and we need to miter the edges to join together. I...

Mine does it eveytime when I use centerline text. I'm not quite sure why.

I upgraded to the newest version of the carvewright designer software and every time I try to upload to the card reader it stops responding and then takes forever to respond. Does anyone know what I...

I did not get a reminder in my email for this months POM. Where and how do I find the new POM to download? Thank you!

We carve mostly into oak and we're wonder what is the life of a carving bit? We use both a 1/16 and 3/16 and have used them less then a year. We use a brass brush to clean the but they're balling...