Yep... You called it EXACTLY... I pulled the board last night and sure enough on of the wires on the large capacitor had broken away from its solder socket! I just bought that board 6 months ago...
Type: Posts; User: jbrunot01; Keyword(s):
Yep... You called it EXACTLY... I pulled the board last night and sure enough on of the wires on the large capacitor had broken away from its solder socket! I just bought that board 6 months ago...
I'm going to have a look at that tonight.
I just recently bought a new one from them because I couldn't get the CUT MOTOR to start up - Now I cant get it to turn off.. LOL
I've got a note into them... We'll see.. Thanks.
The machine is about 5 years old. I did by-pass the safety switches, but it's been running fine for years like that.
Even BEFORE I load a project - like right when I turn the power switch on...
The CUT MOTOR come alive.
WTF???
Jeff Brunot
Marietta, Ga
I just replaced the cut motor brushes...
Started a new carve project and smelled something burning...
Looked thru the small vent slots on the cut motor housing and found that there were sparks...
I just replaced my Carve-Tight Spindle too. Put the new one in last evening... AGAIN... NO WASHER WITH THE KIT. My new Z truck did not have the tapper and the screws were not PHILLIPS HEAD. They...
shopping now for a small dia. carbide bit.
I tried that. I think the machine screw is pretty hard material. I was able to make a small divit in the good end, but unable to drill through or get the threads to turn themselves out.
So I went to remove a 60 deg V bit so I could install my carving bit... placed the T handle in the socket screw - went to back the bolt out and it sheared off. Broke about 1/2 down the length. The...
Does anyone else have this problem...
When I go to use the CUT PATH TOOL - A dialog box opens called CUT OUT CONTROL...
Down at the bottom is a field where you should be able to enter "Max Pass...
I foung one brush was bad / melted... It was the one on the bottom of motor. The side w/ the rectangular air port. Not the side with the RPM Sensor board.
jeff brunot - marietta , Ga
my motor started slowing down then quit too. not sure what's going on.
I guess I'll check the brushes. where is this x-board located?
jeff
Hi Bruce -
Jeff here - over in Marietta.
I've had my machine for 6 mo now. I've been pumping out lots of work. Had a gteat weekend up at the Marietta Square Artists Market. Sold lots of...