Well thank you all for your input.. something worked cause it is whirling away!! I did an adjustment to the y belt and I guess that is what did it .. thank you once again!!
Type: Posts; User: katec911; Keyword(s):
Well thank you all for your input.. something worked cause it is whirling away!! I did an adjustment to the y belt and I guess that is what did it .. thank you once again!!
I am having a problem when I load a piece, the "y" truck doesnt seem to have enough umph to get all the way over to the right of the machine to hit the bit plate lever. If I force it ti will go but...
Above all... dont give up... it is a great machine after you iron out the kinks... and a wonderful hobby!
any chance that Carvewright or any of the guys on here have any they are selling or giving away to those who were unfortunately unable to attend the conference???
Mine did the same on my last project. It took me forever to complete my project. I decided to try and replace my flat I think its called the fcc wire. I had to change it in the past when I had a z...
that certainly is beautiful.. I have been thinking of carving that one myself! nice job!
thank you once again sir! You always seem to come thru for me, Bud .... thanks again!
Once again I am in need of some help by my friends at the forum. I have purchased, received and downloaded the pattern for the business card holder. However, everytime I try to save it, it advised...
wow you are so lucky... you and little red woodshop are living my dream!! I WILL GET THERE!!! Best of luck
also eelamb I appreciate that and I think it might work out better since it is smaller than the one bud suggested.... what a great bunch of guys on here... always get an answer to my questions so...
thank you so much Bud.... once again you come thru!!
I am looking for a small round box pattern. would like it to be about 2-3 inches round and about 2 inches high.. not sure if thats possible... have tried to figure out gimp but I am unable to create...
this sounds like a great time! I may just have to arrange it! question.. I would like to stay at the campground however no prices were to be found.. Please post if possible.. also I would be going...
at least that's where I did... but I can't seem to find it now...
you can update the firmware online at carvewright.com
Does anyone have a mpc of the boyscout emblem? I am in dire need of one to make a thank you gift from a friend who just made eagle scout. I tried to use a clip art but dont know how to make it into...
I had the same problem .. my machine was down for a month. Changed the fsc cable .. then decided to change the z motor.. that worked.. it is very easy to work on these machines .. I have had mine...
I had a z axis stall on my machine for about a month... couldnt clear it at all... finally changed the z motor and it is back running fine. I found if you tried to run a z motor test it would keep...
They are 1/4" corian. back lit by the sun... thank you all for your comments... makes me want to do more of them. I cut them depth .180 height of 450. I went on tips and tricks and used the...
525735257452575
So are you saying that when I buy images in the pattern store, I cannot use them on things that I sell?
very nice... I am relatively new also. Wait till you try a lithophane! I am now hooked on that!!! This forum is great .. I have learned alot! good luck and have fun!
henry .. I am in CT New Haven area
Does anybody know if you can buy the brushes for the cut motor at lowes? I noticed you can buy some things there, but I swore off lowes years ago because of a very bad customer service problem.. but...
so why would my cut motor sound like its speeding up then slowing down... then in the middle of a project it slowed down and stopped altogether... tested the cut motor .. says its running but it...