I guess I should apologize for being so slow on the up take. But then I thought the only dumb question was the unasked question.
Thanks to all that replied. hightechokim thanks for the post, now I...
Type: Posts; User: thumsup; Keyword(s):
I guess I should apologize for being so slow on the up take. But then I thought the only dumb question was the unasked question.
Thanks to all that replied. hightechokim thanks for the post, now I...
No, didn't change a thing. And Yes I did carve a small project with no problem.
Yes, it's the same bit.
Ok here is the quote from the manual
"Y position
State – Numerical Value (0.000)
The Y position sensor monitors the relative position of the side-to-side
motion of the cutting truck. To check...
Oh, and yes I'm using the 3/8" jointing bit.
Well now I'm not sure of this calibration your talking about. I did the Y-axis check as noted above. As stated it worked fine on satuday the sunday it did'nt work but it did carve a project with no...
Morning Jeff,
I wiped the sensor with a cloth. Checked the Y-axis calibration as per the owners manual results was -.130 the first check and -.129 on the second check. Is this within tolerance? ...
Hey Mel, The board is 5" x 28"
Thanks for the responce.
Yes, it does. As stated the machine does all of its moves right up to and including moving the board back and dropping the bit into position. The machine starts up but...
Hey Rav,
No the machine does all of it moves. Set the bit in position moves the board back but doesn't move the bit into position to make the cut. The board moves thru the machine but the bit...
Greeting,
I'm stumped; yesterday I jointed 4 boards for a glue up. This morning I glued them up. Fantastic job. Then I proceeded to joint 4 more boards and nothing. The machine goes thru its...
Hi all,
LHR sent me a new card. That took care of my problem, all is well.
thanks to everyone for helping.
Joe
Thanks guys but not cigar,
Tried it all no workey. I'll just have to wait for CW.
Joe
Hey Jeff,
Thanks for your input. I have exhausted the "owners manual" and the help area in designer, unless I'm missing something the problem I have is not addressed. Hopefully tomorrow (Monday)...
Friends,
I flashed my memory card to 1.120, and uploaded a project. I removed the card from the read/writer and inserted it into my Carvewright. Upon turning the switch on, I see the Carvewright...
Thanks pkunk, didn't work. Appears the machine isn't reading the card.
Should I be able to see the files on the card in "My computer"?
Joe
Yes indeed Bob, this is a great place to receive help.
JohnB, I contacted CW, they informed me they had some issues with
the CD sent out with the machine. The sent me a link to download the...
Hey guys, thanks for the info. CW contact me a bit ago with the info I need.
Thanks again
Joe
Greatings all,
I need a little help with the software for my new CarveWright. While trying to load the software I received the attached error message.
Reload, unload, reload didn't help.
...