I guess things can overheat. SO how much is new cut motor
Type: Posts; User: Bubbabear; Keyword(s):
I guess things can overheat. SO how much is new cut motor
Recommended Liquid Wrench Chain with Moly most ace hardware stores can get it
There is how it was when I opened the cover. First time top has been off since last time it was in shop for them to repair z bundle and some other things
also would this break cause the z axis errors 298 and 308
any suggestions on how to stop this from happening this is number 4 of these cables. one that came on the machine one LHR replaced and two I have replaced the one shown is last one replaced at...
Well finally got feeling well enough to go to the shop and do a carve. I think this box is going to look fantastic once I complete it. Did mine out of rough Cedar.
Think I will send it to my...
Ran it appears to have gone away on mine since I changed to 1.132
If the 0,5,6,1 then set depth (I set mine a .125) didn't fix the broken bit. The I guess I would stop using it. But i certain cases and times I sure do like it. I would also call LHR
Where are you located whats the temps inside your shop. Needs to be at least 55f so the greases are warm enough to let it go up and down the guides properly
Check the contrast button below the 0 on the kepad turn it both ways see if you get lcd
If they did not upgrade the entrance line when you upgrade the box then it could be the line or the transformer on the pole. Could also be corrosion on connectors in the disconnect outside or in the...
SO Ken can we said I made you smile If so then my years in that setup was well worth it
Dan mine does not do that but I keep getting power flucuation errors and stop after 2 new power supplies.
http://www.3inone.com/products/telescoping-spout/
I love the spout and 3-in-1 is a good light weight oil
Ken I know some still do not believe it but since I added lights to the inside of my machine I don't seem to have that issue anymore. here is the link to the thread....
So it is closer to here and no searching
Jon since I don't see where you are located I will also state temps. 55F or higher. When my shop gets about 50 the bit plate almost makes it out far enough. Days like today my tools are lonely. It...
No Chris before you start the setup go 0,5,6,1 on the keypad then it stays set until you change it gives you 4 options as I listed in #17 using the up down arrow key
Chris in 1.132 you can change the cut board to size when you are at the machine. Post 17 in this thread has it in detail
Ike I think it is a great idea. I hope there is a huge turnout so big it makes your head spin. You in my opinion are one of the top rated designers in the forum if not the top rated you do such great...
Very good site Deolman I sure wish we could get Leo LaPort and the whole gang from tech tv back again
Sorry Michael that is what ever one thought I was talking about when I had the problem I was having. But it was the one that is fixed with 1.132 so I thought I would mention it
If I am following this right this is when you have gone to the CW put the card in and setting what pattern you want it ask if you would like for it to cut out the pattern.
When you turn the...
I am mostly with go3d. Ram is dirt cheap right now. You will probably need an antivirus because you will most likely get it on the net to get updates for designer and maybe even Dl some of the...
LG it will go 3/4 3/8 or 1/4