Can anyone help me with making a picture into a pattern?83598
Type: Posts; User: firedawgbw; Keyword(s):
Can anyone help me with making a picture into a pattern?83598
I'm still trying to fix my machine. Guess I'll start from scratch too. Thinking about unloading it all together.
If the FFC ribbon cable is damaged at all, will that keep the cut motor from turning?
I tried the wires both ways from the switch and the motor still does not turn.
I'll check the flex shaft but shouldn't the motor still make some type of noise or try to turn?
Is the 'elevated tech support' worth the extra money?
Ok, I checked the brushes on the old motor out of curiosity. They looked fine. The new cut sensor checked out fine on the sensor check menu when I turned the chuck by hand. I looked at all the boards...
I tugged on the C1 and it was secure. Anyone in the state of Georgia that can help out? No luck with support.
I checked the circuit board underneath and everything looks fine.
I've replaced the cover switch opposite the keyboard already. I'm clueless. I can't get in touch with Carvewright due to the power outage. Is there anywhere to get these machines repaired?
version 1.164
I was getting a check cut motor error message on the machine. After talking to support, I ordered a new cut motor and sensor. After replacing them both, I am getting the same message and the bit is...