I did not get any error message when it came to the cut motor, I did pull out the flex shaft and the spindles spins freely, but when the flex shaft is installed and I perform the cut motor test thats...
Type: Posts; User: bamaman315; Keyword(s):
I did not get any error message when it came to the cut motor, I did pull out the flex shaft and the spindles spins freely, but when the flex shaft is installed and I perform the cut motor test thats...
I was doing some test on my 4 machines , one of them has close door error , I changed the cover switch with no luck so I changed the termination board and nothing message is still there The 2nd...
I have run into a major problem, Lowes used to carry the Utilitech 2.66 in puck light that is used in the lamps. Well I found out today they are no longer available. Does anyone have a different type...
into the cpu to be askew. what does that mean?
Is there any reason I am getting a error message when trying to download this MPC ? It says can't be downloaded securely .
Thanks for any help offered.:confused:
no I have a dust collector attachment that came from carvewright , hooked it to my dust collector hose
Not yet only have 38 1/2 hours on the machine, it is out of warranty due the age , I have had it for about 2 years
I was carving a rotary lamp pattern , I got a check cut motor message. I checked it and did not see any visible issues with it , so I closed the cover and hit the enter key. The motor started up but...
what would cause the machine to carve a rotary pattern but gives you issues when you go to a regular carve pattern , ( coin bank )
When I load the cutting bit it will not go to the bit plate , but...
The truck does have some resistance when the power is off , I push it all the way to the right till the bit plate pops out.
I have cleaned the rails and the rollers and still has resistance.
No 2 different machines with different problems
I am trying to carve the coin back project with this machine also, this machine will not get past the option of loading the cutting bit , wont even go over to the bit plate. Any ideas?
I am trying to carve the coin bank pattern , when it comes to load the cutting bit it will not go down and touch the bit plate and when it comes back to key pad side the bit will not go down and...
I do have an older machine and I had 3 washers on it, I had to use all 3 to get head pressure to 80lbs. Thank you for your advice !
I have gone through the whole process in the procedure to adjust the pressure. Before I started my head pressure was around 50 lbs. After going through the process to adjust machine , I got the...
yes I am using 40 pipe
yes it is Schedule 40
how do you tell? I have used this same pipe for other lamps and it works great. I did try and carve it again but the picture got compressed.
I have a friend that lost her mom and dad within 3 months of each other. I want to make her a rotary lamp with her parents on it. I have the program and I have entered all the settings in the...
When you open up your project look under board settings and see if the right bit is selected. I was under the empression that it automatically picked the right bit , but I was wrong. I am about to go...
I have tried to go a lamp project and have used the settings in the instructions, problem is it carves too deep and ends up carving all the way through the pvc pipe.
any ideas how to correct this?
That was what was wrong, The wrong bit was selected. I was under the impression that when you loaded a rotary pattern it would automatically select the right bit.
I guess you can still learn...
I am using the long carving bit that came with the rotary jig.
Thank you , I did try and measure a board the was 20 3/4 inches long , but machine said it was over 21 1/2 inches long. any ideas?
I have carved this pattern so many times but the last time I tried it the pattern came out smaller. I have always used a 24 inch long board with no problems. This time it came out smaller, I did...