Search:

Type: Posts; User: grt520; Keyword(s):

Search: Search took 0.00 seconds; generated 39 minute(s) ago.

  1. Thread: US-Arizona

    by grt520
    Replies
    16
    Views
    10,454

    SE Mesa, Arizona. Have used CW since 2007.

    SE Mesa, Arizona. Have used CW since 2007.
  2. Replies
    16
    Views
    22,160

    Sticky: Are there limitations to conforming vectors?

    I picked a scroll from the patterns depot. I applied to the cross with dove pattern and used conforming vectors and centerline text to carve out the lettering. This worked fine when my project was...
  3. Upgraded to Designer Pro and old designs take longer and are not as clean!

    i recently upgraded to Designer 3 (Pro) and these text carves that ran in about 40 minutes on the prior release now take 1 hour and 24 minutes AND the text carvings are not nearly as clean. I...
  4. Hi Clint. How does one become a vendor of...

    Hi Clint. How does one become a vendor of projects in pattern depot? I asked that of LHR Tech Support but no response yet. I would appreciate some guidance. Thanks, Gary
  5. Replies
    4
    Views
    1,980

    Thanks Ron. It is the carving bit that I'm using...

    Thanks Ron. It is the carving bit that I'm using and I checked it against the 1/8" cutting bit for the correct length setting. They are the same. So... sounds like it may be the encoder.......
  6. Replies
    4
    Views
    1,980

    Z creep down, cutting too deep.

    :( :( OK... I'm new with this. I've carved 5 boards approximately 7 5/8" X 20" on .8" think African Mohogany. The first 4 were practice to see what the machine would do. The 5th was for real. A...
Results 1 to 6 of 6