Connie, please let me know if there are on your stock the CW Memory Card and the programmer.
Thank you.
Type: Posts; User: gelu_b; Keyword(s):
Connie, please let me know if there are on your stock the CW Memory Card and the programmer.
Thank you.
After your very good question I thought a little and I re-opened the programmer enclosure; then I checked the wires' integrity between USB connector and the input of the PCB: one of the wire seemed...
I opened the programmer and I check it: at the first sight everything seems to be fine (the pins are ok). Then I closed the programmer' enclosure and I did a new try: unfortunately the symptom...
Good point - I'll check it, thank you.
Dear all,
I'm writing here with the hope that someone could help me to solve the following issue: my CW Memory Card suddenly cannot be recognized by the programmer - I get the message "The flash...
At the end I did it with 1/8 inch cutting bit (I think this is faster way). Thank you everybody for the pertinent comments and advices.
I'm thinking that this is the right alternative to solve the issue; however I'm not enlightened why I cannot carve at this reasonable depth (0.7 cm = 0.276 inch and the board thickness is 0.866...
A Happy and Prosperous 2015 New Year for everybody!
I'm doing a simple project but there is something that I don't understand: the carving depth is drastically limited, despite of fact that the...
Sent my project yesterday. I hope you'll receive it in right time.
Hope to get his reply in useful time (if Ineed to ship the project it takes some time till it will be in your hands / I don't wanna to miss the event).
I sent you an email with my entry proposal. Did you receive it?
As this technology is not used since the early '80, the Nixie tubes become more expensive and harder to find from year to year. Thanks to huge military stocks made in ex-USSR, still there are plenty...
I'll be glad to share my little project with the forum community but I don't see the way to do it related to the electronic part (the case project is quite simple and it is easy to do it)
This is mine :) It is the electronic part of the above presented clock.
The electronic design has been made by me, but the Printed Circuit Board has been done by a specialized company.
Thank you AL for your advices and for your kind offer, I'll consider it if it will...
Following my hobby for old Nixie electronic displays, I built an electronic clock boxed in a modern minimalistic design wood case.
Unfortunately my Carvewright "betrayed" me again (the cutting motor...
I finished the version with Fahrenheit scale, too.
Yes, I did it.
After more than one year of learning lessons, trials, disappointments or troubles from my Carvewright machine I'm proud to present my first project: Nixie Electronic Thermometer with Realeaux...
Thank you Al for your complete and pertinent comment. It seems that I have a lot of homework to do ... I already replaced the QC with CT, I'm going to check the rest of the possible causes of the...
I checked the head pressure and it is slightly bellow the minimum of recommended pressure range (68 lbs measured). I greased the vertical guide rods, the head pressure increased a little bit (to 71...
Yes, I stayed under the rollers all the time. Also I setted the max cut depth to 0.2. What should I check to x gears mechanism?
Yes I did.
Hello everyone!
I just changed the standard tracking belts with a new pair of heavy duty model and, trying to cut some circular bases, I got scrap pieces - because of misalignment of the...
Hello everyone,
I'm going to change the original sand paper drive belts with the rubber belts to my Carvewright machine (B model) and kindly I'm asking you to let me know if I could find more data...