roydlandry70,
Do you have the original shipping boxes for both machines?
How many hrs are on each machine?
TIA
Mike
Type: Posts; User: mikemi; Keyword(s):
roydlandry70,
Do you have the original shipping boxes for both machines?
How many hrs are on each machine?
TIA
Mike
Hi deckard,
I noticed in your first post that you are trying to do this cut with a 1/16th cutting bit. I think if you install a 1/8th cutting bit and select that in the cutting depth setup, you...
Good job Oscar. Sure wish I could do that.
Mike
I imagine he means Harbor Freight.
Mike
Very nice Oscar. I am sure they will be very happy with it.
Mike
Well deserved awards. Congrats
Looks like it was the FFC cable after all. I had removed it and inspected it a couple of days ago and didn't see anything obvious. I replaced it today with a new one and after running the same...
I can not figure out what is going on. The carve started out OK, but at 20% the bit started taking a gradual plunge and finally ended with an X error.
Can't find anything obviously wrong and just...
Sorry to see you go Steve. As commented before, you have been a great asset to a lot of Carvewright folks including me.
Mike
Thanks Oscar.
Mike
Very nice Oscar.
Mike
Beautiful work Sharon.
Mike
I'm sure he will like it. Looks great.
Mike
Really nice carve Jerry.
Mike
Does anyone know when the POM for Sept is going to be available?
Mike
Great looking projects Sharon. I can believe what you said about not working in the shop much this summer, it's been too darn HOT!
Mike
Thanks Oscar, that's very nice.
Mike
Great job Oscar.
Mike
Where are you located?
Mike
Does anyone know what the POM is going to be for February or when it is going to emailed out?
Mike
Very nice Dale.
Mike
Dan, I flashed the card with the latest firmware and so far the machine is working fine. Thanks for your suggestion.
Al, if I have the same problem again, I will for sure try your suggestion.
...
Fantastic job Oscar.
Thanks Dan, I flashed the firmware on the card I was using at the time and should be able to try it tomorrow and will see how it works then.
Thanks for your thoughts on this also Al. Everything...
I am having a problem with one of my B machines and I don't know what to do to fix it.
During a carve it works fine, but if I push the STOP button or raise the clear cover the truck stops but the...